EdiLine PLCC Series Datasheet

Transcription

1 PLCC LED Series EdiLine PLCC Series Datasheet Features : Linear Module Design High Efficiency Low Power Consumption Long Operating Lifespan Easy Installation with Screws Typical Applications : General lighting Contour lights Decoration lights Architectural lighting Copyright 2014 Edison Opto Corporation. All right reserved. The information in this document is subject to change without notice. version : 4 1

2 Table of Contents General Information...3 Product Dimensions...4 Absolute Maximum Ratings...5 Electro-Optical Characteristics (T J =25 C)...5 Typical Radiation Pattern...6 Substrate Temperature Measurement Point...7 Optical Curves-Spectrum...8 Revision History...9 About Edison Opto...9 Copyright 2014 Edison Opto Corporation. All right reserved. The information in this document is subject to change without notice. version : 4 2

3 General Information Introduction The linear structure of EdiLine PLCC Series results in an easier heat dissipation requirement, making versatile fixtures design possible as well as an overall cost saving benefit. The special twin connectors design allows EdiLine PLCC to be assembled easily with screws in either serial order as a linear light source or parallel order as a planar light source. Product Nomenclature 5T 0x xx xw L 0xx 000x X1-X2 X3-X4 X5-X6 X7-X8 X9 X10-X12 X13-X16 X1-X2 Module Series X3-X4 Emitter Series X5-X6 Emitter Power X7-X8 Emitting Color X9 Module outline Code Type Code Type Code Type Code Type Code Type 5T PLCC Module 03 PLCC 3528 X5 0.5W CW Cool White L Linear 05 PLCC W NW Neutral White WW Warm White X10-X12 LED No. X13-X16 Series No. Code Type Code Type pcs xxxx pcs Copyright 2014 Edison Opto Corporation. All right reserved. The information in this document is subject to change without notice. version : 4 3

4 Product Dimensions 5T05X5xWL024000x 5T03X5xWL T03X5xWL Notes: 1. All dimensions are in mm. 2. Drawings are not to scale. 3. It is strongly recommended that the temperature of Ts be not higher than 55 o C. (Ts: Substrate Temperature, refer to Substrate Temperature Measurement Point at page 6) 4. General tolerance is 0.3mm. Copyright 2014 Edison Opto Corporation. All right reserved. The information in this document is subject to change without notice. version : 4 4

5 Absolute Maximum Ratings Parameter Symbol Rating Units Transient Surge Voltage V TS 12 V DC Forward Current I F 700 ma DC Forward Current for 5T03X5xWL012000x I F 350 ma LED Junction Temperature T J 120 C Operating Temperature T opr -40 ~ +50 C Storage Temperature T stg -40 ~ +85 C Soldering Temperature C Electro-Optical Characteristics (T J =25 C) EdiLine PLCC Luminous Flux Characteristics (T J =25 C) Order Code Color Input Voltage (V) Test Current (ma) Radiance Angle CCT (K) Flux Typ. 5T03X5CWL T03X5CWL Cool White mA K T03X5NWL T03X5NWL Neutral White mA K T03X5WWL T03X5WWL Warm White mA K T05X5CWL Cool White mA K T05X5NWL Neutral White mA K T05X5WWL Warm White mA K T05X5CWL Cool White mA K T05X5NWL Neutral White mA K T05X5WWL Warm White mA K CRI Copyright 2014 Edison Opto Corporation. All right reserved. The information in this document is subject to change without notice. version : 4 5

6 Typical Radiation Pattern x Relative Intensity (%) 120 oo y Angular Displacement Degree x y Relative Intensity (%) 140 o o Angular Displacement Degree Notes: 1. Flux is measured with an accuracy of ± 10%. 2. CCT selection acc. to CCT groups and an accuracy of ± 300K. 3. Forward Voltage is measured with an accuracy of ± 0.2V. 4. Cool White, Neutral White, Warm White emitters are built with InGaN. Copyright 2014 Edison Opto Corporation. All right reserved. The information in this document is subject to change without notice. version : 4 6

7 Substrate Temperature Measurement Point Ts Ts Ts Notes: 1. It strongly recommend to check the temperature of Ts be below 55 o C while thermal design. 2. For thermal design advice, please refer to EdiLine PLCC Series Lighting Application Guide. 3. Ts: Substrate temperature measurement point Copyright 2014 Edison Opto Corporation. All right reserved. The information in this document is subject to change without notice. version : 4 7

8 Optical Curves-Spectrum Normalized luminous Intensity(%) Cool White Neutral White Warm White Wavelength(nm) Color Spectrum at a typical CCT for EdiLine PLCC Copyright 2014 Edison Opto Corporation. All right reserved. The information in this document is subject to change without notice. version : 4 8

9 Revision History Versions Description Release Date 1 Establish order code information 2013/03/ Update the Product Nomenclature 2. Add product dimensions 3. Update the value of Electro-Optical Characteristics 1. Update Product Dimensions 2. Revise the image of front page 3. Revise Electro-Optical Characteristics 1. Add order code 2. Delete PLCC 3535 (6in1) information 2013/06/ /03/ /06/18 About Edison Opto Edison Opto is a leading manufacturer of high power LED and a solution provider experienced in LDMS. LDMS is an integrated program derived from the four essential technologies in LED lighting applications- Thermal Management, Electrical Scheme, Mechanical Refinement, Optical Optimization, to provide customer with various LED components and modules. More Information about the company and our products can be found at Copyright 2014 Edison Opto. All rights reserved. No part of publication may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photo copy, recording or any other information storage and retrieval system, without prior permission in writing from the publisher. The information in this publication are subject to change without notice. For general assistance please contact: service@edison-opto.com.tw For technical assistance please contact: LED.Detective@edison-opto.com.tw Copyright 2014 Edison Opto Corporation. All right reserved. The information in this document is subject to change without notice. version : 4 9