Installation Guide VSW I AAP. Remote Input and Control Panel Rev. B 03 07

Size: px

Start display at page:

Download "Installation Guide VSW I AAP. Remote Input and Control Panel Rev. B 03 07"

Moses McCarthy
5 years ago
Views:

1 Installation Guide Remote Input and Control Panel Rev. B 03 07

2 Installation and Operation Interface The passive interface features a computer video input and pass-through, an unbalanced stereo input and pass-through, and an input select (Show Me) button. All VGA, audio, and control signals are carried from the rear panel of the to the switcher via a single Extron VGA/audio cable assembly. Front panel features 3 Figure Front panel features a b c Computer video input Input VGA-UXGA, RGBHV, RGBS, RGsB, RsGsBs, component video, or HDTV component video through this 5-pin female VGA connector. Audio input Input unbalanced stereo audio through this 3.5 mm mini audio jack. See the diagram at right. Input select (Show Me) button Pressing this button tells the connected and compatible switcher to select this as the switcher's active input. See "Rear panel features" on the following page. Tip (L) Ring (R) Sleeve ( ) 3.5 mm Stereo Plug Connector (unbalanced) The connected switcher must be compatible with this VGA pin 5 pull-up control feature. The Extron and SW VGArs series switchers are compatible with this feature. Check the user's manuals for these switchers for more detail. The show me feature will not work when connected to SW VGArs series switchers with a circuit board part number of x or x. Use of the show me feature with specific switchers requires that jumpers be set in the. See Setting Jumpers on page 4. Installation and Operation

3 00-40V 0.A 50-60Hz L R Rear panel features Figure Rear panel features a b Audio pass-through Output unbalanced stereo audio through this 3.5 mm mini audio jack. See the previous section's wiring diagram (b). Computer video pass-through Output VGA-UXGA, RGBHV, RGBS, RGsB, RsGsBs, component video, or HDTV component video through this 5-pin female VGA connector. Interfacing to SW VGA Series Switchers The can be connected to each input of a SW VGArs switcher. Pressing the Show Me button causes the switcher to select this input. Refer to the SW VGArs Switchers manual for connection instructions. Projector IPUTS REMOTE SW6 VGA Ars 3 5 OUTPUT OUTPUT 4 6 SW6 VGA Ars Figure 3 Multiple inputs to an SW VGArs switcher Installation and Operation

4 IPUT IPUT IPUT IPUT IPUT IPUT IPUT IPUT Interfacing Interfacing to a Daisy Chain switchers can be daisy chained together to form a presentation system (figure 4). Each switcher connects to a. By pressing the 's Show Me button, the user sends a control signal telling the switcher to select this as the active input. Refer to the Switchers manual for connection instructions. Extron Extron VGA Switcher Extron Extron s pre-made VGA with audio cable assemblies. In In Expandable, economical presentation chain for conference rooms and library study rooms. Out In In Out In In Projector Out Extron s pre-made VGA with audio cable assemblies. Figure 4 Daisy-chained switchers Installation and Operation 3

Configuration Setting Jumpers A jumper (figure 5) on the may need to be shifted, from jumper J6 (the default position) to J5, depending on the switcher to which the VSW is connected.

5 Configuration Setting Jumpers A jumper (figure 5) on the may need to be shifted, from jumper J6 (the default position) to J5, depending on the switcher to which the VSW is connected. Refer to the applicable switcher s manual to see how to determine the switcher s board version or level. J5 J6 Jumper installed J6 J5 Switcher compatibility, board revision C SW VGArs, board part #0-8-0x, board revision A Figure 5 jumper positions If you are daisy chaining with a that has a circuit board that is revision C or higher, install the jumper on J6. If you are daisy chaining with a that has a circuit board that is revision A, install the jumper on J5. If you are daisy chaining with a SW VGArs that has a circuit board whose part number is 0-8-0x, install the jumper on J6. The show me feature will not work when connected to SW VGArs series switchers with a circuit board part number of x or x. 4 Installation and Operation

6 Extron Electronics, USA 30 South Lewis Street Anaheim, CA FAX Extron Electronics, Europe Beeldschermweg 6C 38 AH Amersfoort, The etherlands FAX Extron Electronics, Asia 35 Joo Seng Rd. #04-0 PM Industrial Bldg., Singapore FAX Extron Electronics, Japan Kyodo Building, 6 Ichibancho Chiyoda-ku, Tokyo Japan FAX Extron Electronics. All rights reserved.

RGB 470xi Series DUAL INPUT, ARCHITECTURAL INTERFACES ARCHITECTURAL INTERFACES MHz (-3dB) RGB video bandwidth.

RGB 470xi Series DUAL INPUT, ARCHITECTURAL INTERFACES ARCHITECTURAL INTERFACES MHz (-3dB) RGB video bandwidth. ARCHITECTURAL INTERFACES RGB 470xi Series DUAL, ARCHITECTURAL INTERFACES 300 MHz (-3dB) RGB video bandwidth Two inputs Select inputs using front panel button, contact closure or autoswitch Buffered local