Datasheet IVU.box.touch

Transcription

1 Datasheet IVU.box.touch Standard Features CPU Freescale ARM11 i.mx 532MHz Operating System Microsoft Windows CE 6.0 Internal mass storage device RAM Removable mass storage device Human User Interface (HMI) 1 GB NAND Flash 256MB RAM SD-card 1GB Touch, resistive, scratch resistance on surface 3H 1 / 7

2 Driver display Properties of the TFT: 7 WVGA (5:3) anti-glare TFT Active area 152 (x) x 91 (y) mm 800 (x) x 480 (y) pixel colors (color depth 6bit) Brightness typ. 400 cd/m² Contrast typ. 1000:1 Ambient-light sensor Backlight-LED Display-Mode TN, normally white Brightness-Control of the driver display and passenger s display Measurements according to human eye sensitivity 50Hz flicker-free Vehicle Interfaces Ethernet 1x 10/100BaseT according to IEEE Serial Interfaces 1x IBIS-coach bus slave 1x USB service/diagnosis internal Digital Inputs and Outputs 1x ignition, 2x In- or Output according to VDV standard (one of these may be an location beacon according to VDV standard, and one may be used as a wakeup signal), 1x distance pulse (or speed pulse) according to VDV (may also be used as digital input), 1x distance pulse (or speed pulse) according to VDO Vehicle Data Memory 1x Interface for EEPROM persistent memory in the vehicle UPS Rechargeable battery to bridge power gaps and to power down the device without data loss in the event of power failures Power failure buffering time min. 5 sec 2 / 7

3 Real-time clock Audio Battery-buffered real time clock (RTC) Internal beeper Tone pitch and length software-controlled Loudness 50dB(A) in 1m distance 3 / 7

4 Options Expansion module for Vehicle Interfaces Serial interfaces Digital In-/Outputs Audio 2x RS232 (partial pin assignment, with handshake) 1x RS485 1x IBIS-coach bus Master according to VDV300 1x USB 2.0 (Full-Speed) CAN (optional) 8x combined input active-high active-low according to VDV, 3 can be configured as outputs according to VDV 9x combined in-/output according to VDV 3 channels extern out, 775mV an 600 Ohm 2 channels extern in, 775mV an 600 Ohm Expansion module WLAN Radio interface Wireless LAN 2,4 GHz, 5GHz 54Mbit/s according to IEEE a/b/g/n Expansion module for Communication and Positioning GPS Internal GPS-module (optional, retrofitable) 50 channels 3,3V antenna supply horizontal accuracy < 2,5m CEP (50%) Applicable for Galileo (via Firmware-Update) GSM/GPRS/UMTS- Modem External antenna connector Internal UMTS-modem (optional, retrofitable) HSDPA (max) 7.2 Mbps downlink, 384 kbps uplink EDGE (max) 236,8 downlink, 118 kbps uplink External antenna connector 4 / 7

5 1x audio input, 1x audio output for external handsfree-equipment Note: Not all options can be combined with each other. The exact configuration for the costumer must be determined according to the restrictions, which apply. 5 / 7

6 Technical Details Energy use typ. 19 W ca. 2W in deep sleep mode < 0,2W when switched off Operating voltage 16, V= Operating temperature ambient air Storage Temperature -25 C +70 C -25 C C Air humidity (non-condensing) % Weight Body housing material Width x height x depth (without display adjustment expansion) Ingress protection MTBF 3 kg Metall 210 x 120 x 100 mm IP h Maintenance- und Care Cycles Lifetime backlight > h operating hours Lifetime internal rechargeable batteries Certificates and approvals 5 years CE according to appendix 3C 6 / 7

7 Dimensions Abbildung 1: Front view and side view. Abbildung 2: Top view. 7 / 7