Melrose Veteran s Memorial Middle School Auditorium 250 Lynn Fells Parkway, Melrose, MA, 02176

Transcription

1 Melrose Veteran s Memorial Middle School Auditorium 250 Lynn Fells Parkway, Melrose, MA, /25/2008

2

3 LINESET NAME SIZE PLASTER DIST. BACK WALL OF STAGE SCENIC (PIPE WHITE CYC) 50 X SCENIC PIPE BLACK LEG SET 2 X 8 X th ELECTRIC W/ RACEWAY BLACK BORDER 50 X SCENIC PIPE SCENIC PIPE BLACK LEG SET 2 X 8 X BLACK BORDER 50 X SCENIC PIPE (SCRIM) 50 X SCENIC PIPE rd ELECTRIC W/ RACEWAY BLACK TRAVELER 50 X BLACK BORDER 48 X SCENIC PIPE SCENIC PIPE nd ELECTRIC W/ RACEWAY BLACK LEG SET 2 X 8 X BLACK BORDER 50 X SCENIC PIPE SCENIC PIPE st ELECTRIC W/ RACEWAY MAIN CURTAIN 2 = 2 1 VALANCE 50 X 8 1 = 2 0 FIRE CURTAIN 50 X PROSCENIUM 48 X 18 X 2 0 X 0 EDGE OF APRON -7 FIRST ROW -29 CENTER WHEEL CHAIR RAIL -56 START OF STADIUM SEATING -71 FRONT OF CONTROL BOOTH -102 NOTES The proscenium is 48 wide x18 tall Total Stage width is 84 (22 Stage Left, 14 Stage Right) Grid is at 44 Catwalk position is about 36 up and 28 out All pipes are 60 long Widest point in the auditorium is 107 Typical trims are marked with tape on some linesets Trims for all electrics are marked with a ribbon to line up with bar on wall Melrose Veteran s Memorial Middle School Auditorium 250 Lynn Fells Parkway, Melrose, MA, Scale 1 = 8 MEASUREMENTS

4 Melrose Veteran s Memorial Middle School Auditorium 250 Lynn Fells Parkway, Melrose, MA, Scale 1 = 16 CROSS SECTION

5 FIRE CURTAIN CRANK SOUND RACK COMPANY SWITCH Melrose Veteran s Memorial Middle School Auditorium 250 Lynn Fells Parkway, Melrose, MA, Scale 1 = 16 AUDITORIUM PLAN

6

7

8

9 Audio Input Devices 1 x wireless Shure XLX2 Hand-Held SM58 Microphone 8 x wireless Shure ULX1 Body-Pack Transmitter w/mics 12 x Shure ULXP4 Wireless Receiver 4 x Shure UA844US Antenna Splitter for wireless receivers Note: Wireless mic receivers are in a rack backstage left. 1 x Shure 588SDX unidirectional dynamic microphone 1 x Shure 14A unidirectional dynamic microphone 1 x Shure Beta 57 unidirectional dynamic microphone 1 x Ball style mic of unknown make and model 2 x Denon DNC635 CD players There are also 5 mic cables and 4 table top mic stands available Sound Mixing Equipment There are 2 primary audio mixers in this system The main mixer is a Crest XR channel audio mixer. This mixer is used when the show calls for a sound operator. It is mounted in the portable rack along with the. There is also the Shure Model SCM810/E 8 channel automatic microphone mixer mounted in the rack backstage. This mixer contains electronics that allow it to automatically make adjustments to the mic levels once the initial levels have been set for simple shows. Two AKG K240 professional headphones are available for monitoring or cueing. Input Channels The first 4 channels of the automated mixer are connected to the mic connectors on the front of the stage. 5 and 6 are the 2 line level inputs that are on the front of the stage in the same panel as the video connections. 7 has been left open, and 8 is the feed from the gym. There is a patch panel, so you can rearrange the inputs as needed. The 8 individual outputs from the automated mixer are passed through the Aphex 228 Buffer Amplifier and into the first 8 inputs of the main mixer. 9 through 12 on the main mixer are connected to the 4 microphone connections at the back of the stage. 13 through 24 are wired to the 12 wireless mic receivers. The 2 CD players come in on line inputs 1 through 4 on the mixer. All of the connections between the portable rack and the backstage rack are made through a multi pin cable with a 90 pin connection at the sound mixing position in the auditorium. There is a 24 position patch bay that matches the 24 inputs to the mixer, but remember that the automated mixer is between the patch and the Crest mixer on input channels patch cords were available at last count. PA/Drama Switch There is an important switch that is used to alternate between the mixed output of the automated mixer (labeled PA) and the mono feed from the front of house mixer (labeled Drama). This switch controls all of the audio that is fed to all of the other systems (except the stage monitors). The output of the front of house mixer will not be heard if this switch is in the wrong position. 1 of the 2 outputs of the PA/Drama switch is goes directly to the main system to drive the speakers in the auditorium. The other output goes to a Radio Design Labs RUBDA3 distribution amp that sends sound to all of the other systems. This device has connectors that are seen on the front of the backstage rack, but the actual connections have been made on the back of the device. One output feeds a Shure SCM-288 mono mixer in this circuit and all local system feeds come from this mixer. Additional feeds from the distribution amp go to the Gym and Cafeteria sound systems. Main System Output Components The mono audio from the PA/Drama switch goes to the Shure DFR 22 sound processor. This unit plays several roles that were once performed by many discrete devices. The processor s primary functions are to perform equalization and attempt feedback rejection.there are some controls on the front of this unit, but it is intended to be run from a laptop computer. Most people would do well not to touch this device. Next in the main system is the Renkus-Heinz X12 active crossovers followed by 2 Crown CTS 1200 power amps and a matched pair of Renkus-Heinz STX7 speakers mounted to the ceiling of the auditorium.

10 Stage Monitors The Aux-1 output of the main mixer feeds the stage monitor system. Stage monitors are powered by a Crown CTS-600 power amp. The connections for the stage monitors are on the front of the stage. There are 4 JBL JRX-100 speakers w/cables that can be used as stage monitors or as fill speakers on the apron. Hearing Assistance Devices There is a Telex ST-300 hearing assistance transmitter and 24 Telex SR-400 hearing assistance receivers and earbuds. Recall System A TOA A-912MK2 mixer/amp is provided for the Recall System. This system allows the stage manager to call the dressing rooms (music rooms) as well as provide a warning chime if needed. The main audio can also be mixed into this system to allow people in these areas to hear the show. The mic is labeled Audience Recall but there are no speakers in areas that would be occupied by the audience. Intercom System There are several Audiocom SS2000 Intercom panels around the auditorium plus 1 Audiocom MS2002 Intercom panel that is installed into the rack backstage. There is one panel backstage left, one in each of the 2 music rooms (dressing rooms) as well as to the control booth and the ticket booth. Intercom headsets can be connected to these panels as well as to intercom jacks that are disbursed around the room. There are 8 Telex BP2002 Intercom Beltpacks with 8 matching Telex headsets, and a Telex EGM12N boom mic to be used with the intercom panels. 12 Intercom cables are also provided. A 4 pin cable to be used to extend a headset is available. Video Connections On the front of the apron there is a panel with inputs for SVGA computer video, S-video, and composite video. These terminate in a panel on the ceiling of the control booth, then connected directly to a video projector in the booth. This panel also has signals from the cafeteria and the gym. The panel on the front of the apron has 2 line level audio connections. There is a composite video connection at the audio mixing position. This feeds a Kramer FC7501 composite to SDI encoder before sending it to the gym and the cafeteria. - Power Sequencer (on/off switch) - 8 Channel Automated Mixer - 8 Channel Buffer Amp - Antenna Signal Distribution for Wireless Mics - Antenna Signal Distribution for Wireless Mics - Antenna Signal Distribution for Wireless Mics - Antenna Signal Distribution for Wireless Mics - 2 x Wireless Mic Receivers - 2 x Wireless Mic Receivers - 2 x Wireless Mic Receivers - 2 x Wireless Mic Receivers - 2 x Wireless Mic Receivers - 2 x Wireless Mic Receivers - Local Remote Mix Switch (PA/Drama) - + Recall Mic and Chime - Recall Amp (feeds sound to dressing rooms and ticket booth) - 24 Channel Patch Bay - Intercom Panel - Buffer Amp.- Mono Mixer - Assisted Listening Transmitter - Signal Processor and Feedback Suppressor - Active Crossover for Main System - Active Crossover for Main System - Composite Video to SDI Encoder - Power Amp for Back Wall Speaker Connections - Power Amp for Stage Monitors - Power Amp for Main Speakers - Power Amp for Main Speakers

11 Lighting Inventory Leviton Innovator Lighting console K Leviton i series dimmers (everything above 176 is spoken for) 6 x 19 Leviton #LeL19 Ellipsoidal Reflector Spotlights 24 x 26 Leviton #LeL26 Ellipsoidal Reflector Spotlights 24 x 36 Leviton #LeL36 Ellipsoidal Reflector Spotlights 6 x 50 Leviton #LeL50 Ellipsoidal Reflector Spotlights 12 x Altman PAR-64 (WFL?) 4 x Altman Star-PAR with set of 4 lenses and 4 leaf barn doors 4 x Leviton FR1TH-22B 6 Fresnel with 4 leaf barn door 10 x Altman R cell 4 circuit Striplights (All lights have safety cables, color frames and C-clamps) 2 x Rosco I-Cue Moving Mirrors with PSU50 power supplies 4 x 50lbs Boom Bases, 2 x 12 Booms 12 x 24 Sidearms with 2 tees (Booms and sidearms are available but not installed) 12 x 10 2P+G cables 6 x 25 2P+G cables 9 x 50 2P+G cables 4 x P+G two-fer cables 2 x 25 DMX Cables Lighting Plot A lighting plot has been created that puts all of these instruments in the air. There is a copy of the plot in this document. The schedules exist as a separate Excel spreadsheet. It can be sorted on different columns to create DMX list, Channel list, Gel list, etc.. Everything in the spreadsheet is color coded. The plot contains 9 basic areas and 2 sets of color side washes. There are also a set of areas lit by PARs for when you just need it brighter. The strips on the first and third electrics are gelled White, Yellow, Blue, and Red. The 4th electric is gelled Green, Lt Blue, Red, and Blue. The 4th electric is pretty close to the cyc and doesn t light it very well. I suggest a ground row of cyc lights if possible. In the DMX column you ll notice that some of the addresses are green and some are lavender. There are 20 circuits marked green that have fixtures and are in use, however they should be your first choice when you need to cannibalize the plot. They have been chosen because they are relatively easy to refocus. Please put the plot back the way it was when you are finished. There are about 60 other circuits open and nothing is two-fered. Each of the 216 dimmers are good for 2400 watts. A total of 176 dimmers are available for theatrical use. Circuit Distribution Each of the 216 dimmers are good for 2400 watts. A total of 176 dimmers are available for theatrical use. The catwalk has 44 2P+G circuits on separate dimmers (1-44) Wall boxes with 6 x 20 2P+G circuits on each side of apron(45-50, 51-56) Caution: cables may have to cross traffic areas The Pit has 2 circuits in the middle (57-58) 2 circuits are on the auditorium back wall behind the control booth (59-60) The first electric has 32 2P+G circuits on separate dimmers (61-92) The second electric has 20 x 2P+G circuits (93-111) The third electric has 20 2P+G circuits on separate dimmers ( ) The forth electric has 20 2P+G circuits on separate dimmers ( ) 4 circuits down left 4 more down right ( , ) 6 circuits up left and 6 more up right. ( , ) Caution: cables may have to cross traffic areas Architectural Lighting Control There are a number of push button control stations around the auditorium. Currently there are only 3 functions programmed; (1.) turns on the house lights (2.) turns on the work lights over the stage and (3.) turns on the lights in the control booth. Panels with less than 3 buttons just turn the house lights on and off. The system can be further programmed using a laptop computer. Fly system There are 24 counterweighted linesets. 4 of them are motorized and are setup to be electrics. There is a loading galery with ample weights available. See the measurments page to get information about soft goods. Printing this document This document is a PDF and can be printed at any size. You might want to enlarge to 2X or 4X to give you a larger work area when using the drawings for designing.

12 Melrose Veteran s Memorial Middle School Auditorium 250 Lynn Fells Parkway, Melrose, MA, AUDIO RISER

13 Melrose Veteran s Memorial Middle School Auditorium 250 Lynn Fells Parkway, Melrose, MA, INTERCOM RISER

14 Melrose Veteran s Memorial Middle School Auditorium 250 Lynn Fells Parkway, Melrose, MA, View from the back of the auditorium View from the back of the stage Stage left apron with wheelchair ramp Stage right apron with steps View from audio mixing position