MiraScreen Wire Powered by EZCast

Transcription

1 MiraScreen Wire Powered by EZCast Quick Start Guide Rev Introduction Thanks for choosing MiraScreen! The MiraScreen Wire contains the cutting-edge MiraScreen technology, and firmware upgrade will be provided accordingly in order to compatible with latest devices. Please read the installation guide below to setup your MiraScreen Wire. Let s enjoy mirroring! support@mirascreen.com

2 Hardware Installation Please follow below steps to setup MiraScreen Wire: (1) Connect MiraScreen to your TV (Monitor or Projector) (2) Connect the USB type-a plug with an external (5V) adapter. (3) Connect the lightning plug with your ios* device * Support ios9 and above (4) If the HDMI source is set correctly, you should see the MiraScreen setup screen on TV (5) Wait for a few seconds for initialization*, the screen of your ios device will be shown on TV. * Some ios devices may popup "This accessory may not be supported". Please feel at ease to use as this is a normal notification.

3 Firmware Upgrade (1) Insert a paper clip into the hole on the MiraScreen dongle, and push the key inside the hole to enable HotSpot mode (Internet) (2) Enable Personal HotSpot of your ios* device Note: Cellular (3G/4G) data is needed at your ios device, (3) Download EZCast App, launch it. Click the Wire Button on the right to establish connection, and then click the Menu Button on the left (4) Click the Firmware OTA button Note: Please DO NOT power off during upgrade.

4 Output Resolution (1) Insert a paper clip into the hole on the MiraScreen dongle, and push the key inside the hole to enable HotSpot mode (Internet) (2) Enable Personal HotSpot of your ios* device Note: Cellular (3G/4G) data is needed at your ios device, (3) Launch EZCast App. Click the Wire Button on the right to establish connection, and then click the Menu Button. (4) Click the Setting button (5) Use the keypad to control MiraScreen (6) Switch to your favor output resolution (ex 1080p)

5 2016 Octa Hub E-Commerce Co., Limited. All right reserved. MiraScreen are trademarks of Octa Hub E-Commerce Co., Limited, registered in China and other countries. Other product and company names mentioned herein may be trademarks other respective companies. FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/tv technician for help. FCC Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body