HDMI Extender via Single SC Fiber Support 3D/4K2K Up To 10Km In One Single-mode Fiber

Transcription

1 Description HDMI (High-Definition Multimedia Interface) recently has become increasingly popular in the application of video and audio transmission system. In view of the extreme of electrical performances, however, the traditional copper wire cable imposes limits on signal transmission distance and signal quality. In reality, optical fiber is of low dispersion, which in turn has the strength of longer signal transmission distance and better signal transmission quality in comparison to the traditional copper wire cable. APAC HDMI extender uses single fiber without any copper wire inside, where radio frequency interference phenomenon is literally ruled out, which shows the advantage of high performance and good signal quality as well as low cost. Features Extend digital HDTV data without HDCP up to 10Km Comply with HDMI standard for support 3D and 4K2K. Factory default EDID No RF interference by optical fiber Class 1 laser product complies with EN Application Remote monitor for traffic, industrial, military control LCD, Projector, Plasma display connection Large video wall system Application Note PC LCD TV HDMI cable HDMI cable TX Single-mode Fiber (1SC) 10 Kilo meters RX Page 1 of 5

2 Ordering information Part Number AH-UD-10K-1SC-XX 00: US Plug for AC adaptor 01: EU Plug for AC adaptor 02: BS Plug for AC adaptor 03: AU Plug for AC adaptor This product does not include optical fibers Package include TX module 1 RX module 1 5V adaptor 2 Optional:EU/BS/AU Plug converter of 5V adapter Specification PARAMETER SPECIFICATION NOTE Max length 10Km Max resolution HDMI 1.4 Max video bandwidth HDCP compliant CEC compliant Optical connector Recommended Fiber 3.4 Gbps per channel No Yes Single SC 9/125 um Single-mode fiber Optical property 1310nm 0~70 DegC 1290nm~1330nm Optical Link Power Budget Operating voltage +10 db (min) DC 5V TX: 3W Electrical Power consumption RX: 3W Operating Temperature -10 to 50 Storage Temperatute -20 to 75 5V/600mA 5V/600mA Dimension L W H (mm) Weight 255g TX unit or RX unit Page 2 of 5

3 Requirements HDMI Source (PC) HDMI Sink (LCD TV or Projector) 100~240VAC 50~60Hz 0.2A electricity Adaptor Specification PARAMETER SPECIFICATION NOTE Input 100~240VAC US plug Output DC 5V 2.0 A DC Jack Inside 5V / Outside ground Page 3 of 5

4 HDCP compliant This product does not support HDCP. Installation Step1. Put TX module close to HDMI signal source, such as computers. Step2. Put RX module close to HDMI sink, such as LCD TVs or Projectors. Step3. Connect HDMI cable from TX to Source, and RX to Sink. Step4. Plug in the optical fibers from TX to RX. Step5. Apply 5V adaptor to TX/RX modules. Note 1: Clean fiber connector before plugging in. The dust will impact fiber communication performance. Note 2: The length of HDMI cable should be NOT longer than 2 meters. Note 3: These four indicator in front of the modules represent linking status. These 3 LEDs blaze green if all setup is complete and correct. The left one stands for the connection of power. The second light stands for the connection of HDMI Sorce/Sink. The third light stands for the connection of fiber between the TX and RX module. Page 4 of 5

5 Dimensions Fiber HDMI Power Input Power Source Link All dimensions all in +/- 0.3mm tolerance if no specified Unit:mm Safety Regulation CE and FCC approved. Page 5 of 5