Distributed by. CircFlow. Pulse Massager. Instruction Manual and Warranty Information FCB250H

Transcription

1 Distributed by CircFlow TM Pulse Massager Instruction Manual and Warranty Information 1 FCB250H

2 CONTENTS Page 2 What s in the box Page 3 Start Guide Page 4 Infrared plus Tips Page 5-6 Safety instructions Page 6 Troubleshooting Page 7 Reflexology Chart Page 8 Warranty THANK YOU! For purchasing the HoMedics CircFlow TM Pulse Massager. Please read the following instruction manual to ensure you get the most out of this product. The HoMedics CircFlow TM Pulse Massager uses electromagnetic signals to improve the circulation through the planar muscle, which can help alleviate tired and aching legs and feet. What s in the box? Intensity wave display Electrode Jack Infrared Lights Stimulation Plates Also included- Remote Stimulation Pads and Cables Stimulation Waist Belt AC Adapter Slimming Waist Belt Full Instruction Manual Infrared Switch DC Jack Time Display Auto/mode Body Intensity Display Sole Intensity Display Auto/mode Power Inc+ Dec - Function START GUIDE 1. Connect the AC adaptor to the AC jack on the side of the CircFlow Pulse Massager. Then connect the adaptor to a convenient power point. To turn the product on press the Power button. 2. select the required function Sole, Body or Auto mode. You are now ready to start using your HoMedics CircFlow Pulse Massager. Foot Reflexology Massage - Place your feet on the stimulation panels. - If you require heat for your massage the press the Heat button. - Now adjust the pulse intensity by pressing the Inc + button to increase the intensity or Dec button to reduce the intensity. Individual tolerance may vary but you should be feeling some sensation at around 10. Body Stimulation Massage - To alleviate aching muscles use the stimulation pads and cables. - Connect the clips to the back of the pads, peel the backing paper off and place on the area to be treated. Multiple pads can be used to threat bigger muscle groups. - For biceps and triceps place the pad between each end of the muscle. - For trapezoids place the pads on each shoulder blade just below the neck - For the pectorals place the ads above and to the outside of the nipple area. Waist Belt Usage - Connect the cable clips to the connectors on the waist belt. - For the lower back, tummy or obliques place the contacts on the waist belt across the desired area. - For each of the above areas, start by setting the intensity control at a low or zero level and increase the intensity slowly to your desired level. - For the best results you need to ensure that the muscles are contracting and not just tingling. Auto Mode Programs - The AUTO/MODE button allows you to switch between MANUAL mode and AUTO mode. In manual mode the product will remain on the one setting for 25 minutes. In auto mode the product will cycle through a series of 25 beneficial settings for 25 minutes. This is the recommended mode. Selecting the TIME indicator and using the INC+ and DEC- buttons can adjust these times. 3. Using the remote control - The remote control will operate all functions. - Remove the transparent insulation flake from the battery door before use. - Point the remote control at the unit and make your selections by pressing the appropriate buttons. 2 3

3 INFRARED The infrared setting uses warming heat to assist with circulation and warmth to the soles of your feet. Tips At first, try a few different intensity levels, to work out your optimum setting. You should feel a slight tingling sensation when the device is in use. The product has 99 intensity settings so there is sure to be setting that s right for you. Always start at the lowest setting and increase slowly to your desired intensity level. Ensure the desired area is clean and dry before use so the stimulation pads can have maximum contact with your skin. This manual provides a diagram of Chinese point therapy trigger points. These are the optimum places to use the pads. When using the on the body you can use the infrared settings separately. Safety Instructions Do not adjust the intensity level higher than is comfortable. If your skin appears sore or red, while using the device: - Turn down the intensity - If this does not help, stop using the product During the treatment, if you feel skin discomfort (mid tingling sensations) this is normal. This will subside almost immediately after you stop using the product. When connecting and disconnecting any wires from the product ensure that you remove them by holding the plastic retainer plug, not the wire, as this can damage the pads. Ensure your feet are dry before placing them on the device. Do not use while sleeping. This product is not suitable for children If you feel any discomfort or nausea while using the device, stop immediately. It is advisable to only use the product for a maximum of 25 minutes at a time. This device is not suitable for the following: PEOPLE Pregnant women Users of Pacemakers or automatic implanted Cardiac defibrillators Diabetics Existing Deep Vein Thrombosis (DVT) sufferers AREAS Broken or bleeding skin Eyes Genital area 4 5

4 Safety Instructions CONT... REFLEXOLOGY CHART Take care using the device on the following areas: Muscle or ligament sprains/tears rest first then use a low intensity and/or a shorter duration to avoid over stimulation. Devitalised/numb tissue ensure not to over stimulate the area. long term immobility or inactivity use a low intensity and shorter duration to introduce the muscles and avoid over stimulation/muscle fatigue. Trouble shooting Fault The product will not power on after pressing the ON/OFF button. Trouble shooting step 1. First, inspect that the power is on. 2. Check the plug at both ends, to ensure it is connected properly. Fault The Stimulation pads are not working Trouble shooting step 1. Check to see if the stimulation cable is in the correct pin socket. 2. Try increasing the intensity. 3. Check to see if the pads have good contact with the skin. 6 7

5 Distributed by ONE YEAR LIMITED WARRANTY 2012 HoMedics, Inc. and its affiliated companies, all rights reserved. HoMedics is a registered trademark of HoMedics, Inc. and its affiliated companies. All rights reserved. Contact: HoMedics Australia Pty Ltd Level 1, 2-10 Gaine Road, Dandenong South, 3175 Phone: (03) IB-FCB250H HoMedics sells its products with the intent that they are free of defects in manufacture and workmanship for a period of one year from the date of original purchase, except as noted below. HoMedics warrants that its products will be free of defects in material and workmanship under normal use and service. This warranty extends only to consumers and does not extend to Retailers. HoMedics does not authorise anyone, including, but not limited to, Retailers, the subsequent consumer purchaser of the product from a Retailer or remote purchasers, to obligate HoMedics in any way beyond the terms set forth herein. This warranty does not cover damage caused by misuse or abuse; accident; the attachment of any unauthorised accessory; alteration to the product; improper installation; unauthorised repairs or modifications; improper use of electrical/power supply; loss of power; dropped product; malfunction or damage of an operating part from failure to provide manufacturer s recommended maintenance; transportation damage; theft; neglect; vandalism; or environmental conditions; loss of use during the period the product is at a repair facility or otherwise awaiting parts or repair; or any other conditions whatsoever that are beyond the control of HoMedics. This warranty is effective only if the product is purchased and operated in the country in which the product is purchased. A product that requires modifications or adoption to enable it to operate in any other country than the country for which it was designed, manufactured, approved and/or authorised, or repair of products damaged by these modifications is not covered under this warranty. THE WARRANTY PROVIDED HEREIN SHALL BE THE SOLE AND EXCLUSIVE WARRANTY. THERE SHALL BE NO OTHER WARRANTIES EXPRESS OR IMPLIED INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS OR ANY OTHER OBLIGATION ON THE PART OF THE COMPANY WITH RESPECT TO PRODUCTS COVERED BY THIS WARRANTY. HOMEDICS SHALL HAVE NO LIABILITY FOR ANY INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES. IN NO EVENT SHALL THIS WARRANTY REQUIRE MORE THAN THE REPAIR OR REPLACEMENT OF ANY PART OR PARTS WHICH ARE FOUND TO BE DEFECTIVE WITHIN THE EFFECTIVE PERIOD OF THE WARRANTY. NO REFUNDS WILL BE GIVEN. IF REPLACEMENT PARTS FOR DEFECTIVE MATERIALS ARE NOT AVAILABLE, HOMEDICS RESERVES THE RIGHT TO MAKE PRODUCT SUBSTITUTIONS IN LIEU OF REPAIR OR REPLACEMENT. This warranty does not extend to the purchase of opened, used, repaired, repackaged and/or resealed products, including but not limited to sale of such products on Internet auction sites and/ or sales of such products by surplus or bulk resellers. Any and all warranties or guarantees shall immediately cease and terminate as to any products or parts thereof which are repaired, replaced, altered, or modified, without the prior express and written consent of HoMedics. This Warranty statement complies with Regulation 90 of the Australian Competition and Consumer Act 2010 Our goods come with guarantees that cannot be excluded under Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for any compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. This warranty provides you with specific legal rights. You may have additional rights which may vary from country to country. Because of individual country regulations, some of the above limitations and exclusions may not apply to you. For more information regarding our product line in Australia, please visit: 8