ZV-Z81_models5_9_29_dat-sw_en_5213-6864-22_Cover.indd 1 Data Sheet 04.01 Test & Measurement R&S ZV-Z81 Multiport Test Set, models.05/.09/.29 Specifications 17.04.2013 12:47:27
CONTENTS Definitions... 3 Specifications... 4 Performance data... 5 Remote control... 6 Switching times... 6 General data... 6 Ordering information... 7 2 Rohde & Schwarz R&S ZV-Z81Multiport Test Set, models.05/.09/.29
Definitions General Product data applies under the following conditions: Three hours storage at ambient temperature followed by 30 minutes warm-up operation Specified environmental conditions met Recommended calibration interval adhered to All internal automatic adjustments performed, if applicable Specifications with limits Represent warranted product performance by means of a range of values for the specified parameter. These specifications are marked with limiting symbols such as <,, >,, ±, or descriptions such as maximum, limit of, minimum. Compliance is ensured by testing or is derived from the design. Test limits are narrowed by guard bands to take into account measurement uncertainties, drift and aging, if applicable. Specifications without limits Represent warranted product performance for the specified parameter. These specifications are not specially marked and represent values with no or negligible deviations from the given value (e.g. dimensions or resolution of a setting parameter). Compliance is ensured by design. Typical data (typ.) Characterizes product performance by means of representative information for the given parameter. When marked with <, > or as a range, it represents the performance met by approximately 80 % of the instruments at production time. Otherwise, it represents the mean value. Nominal values (nom.) Characterize product performance by means of a representative value for the given parameter (e.g. nominal impedance). In contrast to typical data, a statistical evaluation does not take place and the parameter is not tested during production. Measured values (meas.) Characterize expected product performance by means of measurement results gained from individual samples. Uncertainties Represent limits of measurement uncertainty for a given measurand. Uncertainty is defined with a coverage factor of 2 and has been calculated in line with the rules of the Guide to the Expression of Uncertainty in Measurement (GUM), taking into account environmental conditions, aging, wear and tear. Device settings and GUI parameters are indicated as follows: parameter: value. Typical data as well as nominal and measured values are not warranted by Rohde & Schwarz. Rohde & Schwarz R&S ZV-Z81 Multiport Test Set, models.05/.09/.29 3
Specifications Frequency range models.05/.09 50 MHz to 24 GHz model.29 50 MHz to 8.5 GHz Impedance 50 Ω VNA port connector type K (2.92 mm), female Number of VNA ports all models 2 Test port connector type K (2.92 mm), female Number of test ports model.05 5 models.09/.29 9 Switching configuration see block diagram full crossbar Type of switches electronic Damage level +23 dbm Damage DC voltage 12 V B VNA ports D SP5T SP5T SP3T SP3T SP3T SP3T SP3T 1 2 3 4 5 Test ports Block diagram of the R&S ZV-Z81 model.05. B VNA ports D SP5T 1 2 3 4 5 SP5T 1 2 3 4 5 SP5T SP5T 1 2 3 4 5 1 2 3 4 5 SP3T SP3T SP3T SP3T SP3T SP3T SP3T SP3T SP3T 1 2 3 4 5 6 7 8 9 Test ports Block diagram of the R&S ZV-Z81 models.09/.29. 4 Rohde & Schwarz R&S ZV-Z81Multiport Test Set, models.05/.09/.29
Performance data Insertion loss R&S ZV-Z81 model.05 any VNA port to any test port 50 MHz to 8 GHz < 9 db, 7.5 db (typ.) 8 GHz to 18 GHz < 11 db, 9.5 db (typ.) 18 GHz to 24 GHz < 15 db, 13 db (typ.) R&S ZV-Z81 model.09 VNA port B to test ports 1 to 4 50 MHz to 8 GHz < 9 db, 7.5 db (typ.) 8 GHz to 18 GHz < 11 db, 9.5 db (typ.) 18 GHz to 24 GHz < 15 db, 13 db (typ.) VNA port D to test ports 6 to 9 50 MHz to 8 GHz < 9 db, 7.5 db (typ.) 8 GHz to 18 GHz < 11 db, 9.5 db (typ.) 18 GHz to 24 GHz < 15 db, 13 db (typ.) VNA port B to test ports 5 to 9 50 MHz to 8 GHz < 13 db, 11.5 db (typ.) 8 GHz to 18 GHz < 18 db, 15.5 db (typ.) 18 GHz to 24 GHz < 20 db, 17 db (typ.) VNA port D to test ports 1 to 5 50 MHz to 8 GHz < 13 db, 11.5 db (typ.) 8 GHz to 18 GHz < 18 db, 15.5 db (typ.) 18 GHz to 24 GHz < 20 db, 17 db (typ.) R&S ZV-Z81 model.29 VNA port B to test ports 1 to 4 50 MHz to 8.5 GHz < 9 db, 7.5 db (typ.) VNA port D to test ports 6 to 9 50 MHz to 8.5 GHz < 9 db, 7.5 db (typ.) VNA port B to test ports 5 to 9 50 MHz to 8.5 GHz < 13 db, 11.5 db (typ.) VNA port D to test ports 1 to 5 50 MHz to 8.5 GHz < 13 db, 11.5 db (typ.) Load match R&S ZV-Z81 models.05/.09 any selected test port 50 MHz to 8 GHz > 8 db, 14 db (typ.) 8 GHz to 18 GHz > 6 db, 12 db (typ.) 18 GHz to 24 GHz > 5 db, 11 db (typ.) any unselected test port 50 MHz to 8 GHz > 10 db, 15 db (typ.) 8 GHz to 18 GHz > 10 db, 14 db (typ.) 18 GHz to 24 GHz > 9 db, 13 db (typ.) R&S ZV-Z81 model.29 any selected test port 50 MHz to 8.5 GHz > 8 db, 14 db (typ.) any unselected test port 50 MHz to 8.5 GHz > 10 db, 15 db (typ.) Isolation R&S ZV-Z81 models.05/.09 any unselected test port to any VNA port 50 MHz to 8 GHz > 90 db 8 GHz to 24 GHz > 80 db R&S ZV-Z81 model.29 any unselected test port to any VNA port 50 MHz to 8.5 GHz > 90 db Rohde & Schwarz R&S ZV-Z81 Multiport Test Set, models.05/.09/.29 5
Remote control USB LAN RS-232 universal serial bus connector (type B) for connecting the multiport test set with a vector network analyzer of the R&S ZVA/ZVB family local area network connector, 10/100BaseT, RJ-45 serial port connector, 9-pin, DB-9 (115 kbps/8n1) Switching times USB with software handshake turned on 10 ms (nom.) LAN with software handshake turned on 12 ms (nom.) RS-232 with software handshake turned on 8 ms (nom.) General data Temperature loading in line with IEC 60068-2-1 and IEC 60068-2-2 operating temperature range +5 C to +40 C permissible temperature range 0 C to +50 C storage temperature range 40 C to +70 C Damp heat +40 C at 95 % rel. humidity in line with IEC 60068-2-30 Mechanical resistance Vibration sinusoidal 5 Hz to 150 Hz in line with IEC 60068-2-6 random 10 Hz to 300 Hz in line with IEC 60068-2-64 Shock 40 g shock spectrum in line with IEC 60068-2-27, MIL-STD-810 Calibration interval 1 year EMC RF emission in line with CISPR 11/EN 55011 group 1 class A (for a shielded test setup); instrument complies with the emission requirements stipulated by EN 55011 and EN 61326-1 class A; this means that the instrument is suitable for use in industrial environments immunity in line with EMC Directive 2004/108/EC including: IEC/EN 61326-1 (immunity test requirement for industrial environment, EN 61326 table 2), IEC/EN 61326-2-1, IEC/EN 61000-3-2, IEC/EN 61000-3-3 Safety in line with IEC 61010-1 and EN 61010-1 Power supply 100 V to 240 V (AC) ± 10 %, 50 Hz to 60 Hz ± 5 %, safety class I Power consumption 100 W Certification mark CE conformity mark Dimensions ( W H D ) 462.7 mm 132.1 mm 450 mm (18.22 in 5.20 in 17.72 in) Weight 6 kg (13.23 lb) 6 Rohde & Schwarz R&S ZV-Z81Multiport Test Set, models.05/.09/.29
Ordering information Designation Type Order No. Multiport Test Set 24 GHz, 2 to 5 ports, model.05 R&S ZV-Z81 5200.6790.05 24 GHz, 2 to 9 ports, model.09 R&S ZV-Z81 5200.6790.09 8.5 GHz, 2 to 9 ports, model.29 R&S ZV-Z81 5200.6790.29 Rohde & Schwarz R&S ZV-Z81 Multiport Test Set, models.05/.09/.29 7
Service you can rely on Worldwide Local and personalized Customized and flexible Uncompromising quality Long-term dependability About Rohde & Schwarz Rohde & Schwarz is an independent group of companies specializing in electronics. It is a leading supplier of solutions in the fields of test and measurement, broadcasting, radiomonitoring and radiolocation, as well as secure communications. Established more than 75 years ago, Rohde & Schwarz has a global presence and a dedicated service network in over 70 countries. Company headquarters are in Munich, Germany. Environmental commitment Energy-efficient products Continuous improvement in environmental sustainability ISO 14001-certified environmental management system Certified Quality System ISO 9001 Rohde & Schwarz GmbH & Co. KG www.rohde-schwarz.com Regional contact Europe, Africa, Middle East +49 89 4129 12345 customersupport@rohde-schwarz.com North America 1 888 TEST RSA (1 888 837 87 72) customer.support@rsa.rohde-schwarz.com Latin America +1 410 910 79 88 customersupport.la@rohde-schwarz.com Asia/Pacific +65 65 13 04 88 customersupport.asia@rohde-schwarz.com China +86 800 810 8228/+86 400 650 5896 customersupport.china@rohde-schwarz.com R&S is a registered trademark of Rohde & Schwarz GmbH & Co. KG Trade names are trademarks of the owners Printed in Germany (wb) PD 5213.6864.22 Version 04.01 April 2013 R&S ZV-Z81, models.05/.09/.29 Subject to change 2006-2013 Rohde & Schwarz GmbH & Co. KG 81671 München, Germany 5213686422