WESLEYAN U N I V E R S I T Y Facilities 170 Long Lane Middletown, Connecticut 06457 (860) 685-3476 FAX (860) 685-3101 ADDENDUM #3 Date: March 4, 2013 Project: To: CFA A Rehearsal Hall AHU Replacement Annual Major Maintenance FY 13 Bidders of Record SPECIAL NOTE: Addendum #3 information shall supersede the information contained in the Contract Documents This Addendum forms a part of the Contract Documents and modifies the original Bidding Documents dated January 4, 2013 and February 20, 2013 and any prior Addenda remain in full force and effect except as modified by the following, which shall have precedence over any contrary provisions in prior Documents. Acknowledge receipt of this Addendum in the space provided on the Bid Form. Failure to do so may subject the Bidder to disqualification. The proposed Contract Documents for this project are modified as follows: SK-E-1: Note #7. Contractor to provide new CAT 6 cable in relocated data receptacle. Notes #16 & #23: Contractor to salvage existing track lighting. Addendum #2 address new track lighting to be installed. Note #34: Contractor to provide quad receptacle in lieu of duplex receptacle to be relocated to accommodate new switch and existing wireless data hub. Note #38 (NEW): Contractor to install new 1 Gb switch on wall provided by Owner. Contractor to install new Patch Panel on wall provided by Owner. Contractor to provide and install (1) 1 Gb Corning armored plenum cable from box in data closet 016 to new box in Mechanical Room 015. Provide ST connectors at both ends. Note #39 (NEW): Quad receptacle under rack to remain. SK-E-2: Contractor to provide new courtesy duplex receptacle in basement level closet adjacent to new heat pump. Contractor to provide new 1 x 4 ceiling mounted, T-8, utility fixture above heat pump. In Room RH003; contractor to connect CAT6 cables to new switch in Mechanical Room 015 and not back to data closet 016. In Room RH001; contractor to connect CAT6 cables to new switch in Mechanical Room 015 and not back to data closet 016. Major Maintenance FY2013/2014 Addendum #3 Project Number 2014000000 3/04/13
SK-E-3: Contractor to determine best routing of CAT 6 from Crowell Concert Hall front of stage to switch room 016 and then to control room RH013. Existing conduit may be used. Contractor to provide and install (1) 1 Gb Corning armored plenum cable from box in switch closet 016 to new box in Mechanical Room 015. Provide ST connectors at both ends. Contractor to pull (2) new CAT6 data cables from mixer at back of Crowell Concert Hall to switch room 016. Contractor can pull through audio snake conduit from mixer to 019 and then to 016. Then pull from patch panel in switch room 016 to control room 013. Please contact this office with any conflicts noted within this addendum. Attachments: SK-E-1: Electrical Plan dated 3/4/13 SK-E2: Electrical Plan dated 3/4/13 SK-E3: Basement Electrical Plan dated 3/4/13 Corning MIC Tight-Buffered, Interlocking Armored Cable, Plenum 6F, single-mode Major Maintenance FY2013/2014 Addendum #3 Project Number 2014000000 3/04/13
26.61 115 0 False Corning Cable 210.9857 MIC Tight-Buffered, Interlocking Armored Cable, Plenum 6 F, Single-mode (OS2) Corning Cable Systems MIC Interlocking Armored Plenum Cables are designed for use in plenum, riser and general purpose environments for intrabuilding backbone and horizontal installations. These multifiber cables use individually jacketed TBII Buffered Fibers enabling easy, consistent stripping and facilitating termination. The fibers are grouped into jacketed subunits and surrounded by a dielectric central member. The core is protected by a flexible, spirally wrapped, aluminum interlocking armor that offers easy, one -step installation and over seven times the crush protection of unarmored cables. With a flame -retardant outer jacket, this cable is particularly useful for heavy traffic or more challenging mechanical exposure conditions and applications requiring extra rugged cables. This cable is available in 12 different jacket colors - blue, orange, green, brown, slate, white, red, black, yellow, purple, rose and aqua. The colored jacket allows for easy visual identification of the cables. The standard jacket color will be determined by the dominant fiber type in the cable and will use the standard part numbers shown here. Contact Customer Care at 1-800-743-2675 to order other color options. Part Number: 006E88-31131-A3 Features and Benefits Flexible, interlocking armor design Seven times crush protection compared to unarmored cables TBII Buffered Fibers Easy, consistent stripping Flame-retardant jacket Rugged and durable Flame-Retardant Outer Jacket Interlocking Armor Flame-Retardant Inner Jacket Dielectric Strength Members Dielectric Strength Members Tight-Buffered Fiber Ripcord 1 1 Standards Cross Section of Part Number: 006E88-31131-A3 Approval and Listings National Electrical Code (NEC ) OFCP, CSA FT-6, ICEA S-83-596 Flame Resistance NFPA 262 (for plenum, riser and general building applications) Product Specification 006E88-31131-A3_NAFTA_AEN Page 1 Revision date 2013-01-27
MIC Tight-Buffered, Interlocking Armored Cable, Plenum 6 F, Single-mode (OS2) Specifications General Specifications Environment Application Cable Type Product Type Flame Rating Fiber Category Indoor General Purpose Horizontal, Vertical Riser, Plenum Tight-Buffered Interlocking armor Plenum (OFCP) Single-mode (OS2) Temperature Range Storage Installation Operation -40 C to 70 C (-40 F to 158 F) 0 C to 60 C (32 F to 140 F) 0 C to 70 C (32 F to 158 F) Cable Design Central Element Yarn Fiber Count 6 Tight Buffer Color Blue, Orange, Green, Brown, Slate, White Tensile Strength Elements and/or Armoring - Layer 1 Dielectric strength members Number of Ripcords 2 Inner Jacket Material Flame-retardant Tensile Strength Elements and/or Armoring - Layer 3 Interlocking armor Outer Jacket Material Flame-retardant Outer Jacket Color Yellow Mechanical Characteristics Cable Nominal Inner Cable Diameter Nominal Outer Diameter Weight Max. Tensile Strengths, Short-Term Max. Tensile Strengths, Long-Term Min. Bend Radius Installation Min. Bend Radius Operation 5.3 mm (0.21 in) 12.2 mm (0.48 in) 138 kg/km (92 lb/1000 ft) 440 N (100 lbf) 132 N (30 lbf) 183 mm (7.2 in) 122 mm (4.8 in) Product Specification 006E88-31131-A3_NAFTA_AEN Page 2 Revision date 2013-01-27
MIC Tight-Buffered, Interlocking Armored Cable, Plenum 6 F, Single-mode (OS2) Fiber Specifications Optical Characteristics (cabled) Fiber Type Single-mode Fiber Core Diameter 8.2 μm Fiber Category OS2 Fiber Code E Performance Option Code 31 Wavelengths 1310 nm / 1383 nm / 1550 nm Maximum Attenuation 0.65 db/km / 0.65 db/km / 0.5 db/km Serial 1 Gigabit Ethernet 5000 m / - / - Serial 10 Gigabit Ethernet 10000 m / - / 40000 m * ITU-T G.652 D compliant. Notes: 1) Improved attenuation and bandwidth options available. 2) Bend-insensitive single-mode fibers available on request. 3) Contact a Corning Cable Systems Customer Care Representative for additional information. Ordering Information Part Number Product Description 006E88-31131-A3 MIC Tight-Buffered, Interlocking Armored Cable, Plenum, 6 F, Single-mode (OS2) Corning Cable S stems LLC PO Box ickor, C 2 6 - SA - -26 FA 2-2 - 6 International - 2 - - corning com cables stems A complete listing of the trademarks of Corning Cable Systems is available at www.corning.com/cablesystems/trademarks. Corning Cable Systems is ISO 9001 certified. 2012 Corning Cable Systems. All rights reserved. Product Specification 006E88-31131-A3_NAFTA_AEN Page 3 Revision date 2013-01-27