Instruction Manual Wireless Transmitters (Digital) RVS-550W Reverse With Confidence 1
TABLE OF CONTENTS In The Box 1 x Transmitter 1 x Receiver TABLE OF CONTENTS Table of Contents................................ 2 Introduction.................................. 3 Installation - Power Source............................. 4 Installation - Drilling Diagrams........................ 5 Installation - Height Position.......................... 6-7 Pairing.................................... 8-9 Specifications............................... 10-11 Wireless System Pairing............................ 12 Connection.............................. 13 User Interface.............................. 14-15 Warranty............................... 16 Disclaimer............................... 17 2 Rear View Safety
NOTE! Please read all of the installation instructions carefully before installing the product. Improper installation will void manufacturer s warranty. Congratulations on purchasing Rear View Wireless Transmitters! These Rear View Safety Wireless transmitters turn any camera and monitors into a wireless backup camera system! Simply connect any RVS camera to the transmitter and any monitor with RCA inputs to the receiver for a crystal clear connection! This wireless connection is digital, which means no interference from other devices. INTRODUCTION Read this manual to properly install and operate the unit. These wireless transmitters are intended to be installed as a supplement aid to your standard rear view mirror that already exists in your vehicle. These wireless transmitters should not be used as a substitute for the standard rear view mirror or for any other mirror that exists in your vehicle. In some jurisdictions, it is unlawful for a person to drive a motor vehicle equipped with a TV viewer or screen located forward of the back of the driver s seat or in any location that is visible, directly or indirectly, to the driver while operating the vehicle. Reverse With Confidence 3
INSTALLATION - POWER SOURCE Installation- Power Source Both components must be connected to a +12V power source (red wire) and to ground power (black wire). A RCA-MP is required to power the receiver. Antennas should be installed parallel to each other. Transmitter Receiver 5 pin to camera GND ACC RCA to Monitor Power In 4 Rear View Safety
INSTALLATION - DRILLING DIAGRAMS Installation - Drilling Diagrams Reverse With Confidence 5
INSTALLATION - HEIGHT POSITION Installation - Height Position Install Receiver and Transmitter as high as possible inside the cabin and cargo space without interfering with the functionality of the vehicle. Route cables avoiding areas that may pinch or damage the wires. On the Transmitter module, connect the red wire to a switched +12V power source and the black wire to ground (a non-painted bare metal surface) to each other for optimal performance. 6 Rear View Safety
INSTALLATION - HEIGHT POSITION Best signal strength will be accomplished when both antennas can 'see' each other with minimal obstacles in between. Once the Receiver and Transmitter are connected (linked) to each other the pairing process does not have to be repeated after the main power is disconnected. The established link will be stored by the memory function of the Transmitter module in order to ensure quick startup after disconnecting and re-connecting the main power. Reverse With Confidence 7
PAIRING Pairing Instructions 1) Both the Blue Power LED and the Green Link LED will turn on when power is connected to both components. 2) Press the PAIR button for 3 seconds on both the receiver and the transmitter. The green Link LED will blink to indicate the pairing has started. 3) A timer will appear on the connected monitor. After 50 seconds, the green Link LEDs will stop blinking and become solid. 8 Rear View Safety
4) After the system is linked, the display will show wireless strength with 4 vertical bars. 1 bar indicates a weak connection, while 4 bars indicates maximum connection. PAIRING Note: If the connection is weak, it is recommended to reposition the receiver and transmitter. 5) Users only have to pair one time. Once the two parts are connected the pairing process does not have to be repeated once power is disconnected. Reverse With Confidence 9
SPECIFICATIONS Specifications - System Operating frequency 2400MHZ-2483MHZ Modulation system FSK Max. range 150-200M (in free space) Operating temperature -30 C - 80 C Operating current 0.13-0.17A IP Rating IP69K Specifications - Transmitter Power supply 11-32V Video input CVBS 1.0VP-P, 75Ω Audio input AUDIO MAX 2VP-P, 50Ω TPU cable length Approx. 400cm Dimensions 131 x 100 x 25.6mm Weight 0.266 KG 10 Rear View Safety
Specifications - Receiver Power supply 11-32V Video output CVBS 1.0VP-P,75Ω Audio output AUDIO MAX 2 vz gvp-p,50ω Pixels 720x576 TV system NTSC Frame rate 25-30 frames/sec TPU cable length Approx. 600cm Dimensions 131 x 100 x 25.6mm Weight 0.254 KG SPECIFICATIONS Reverse With Confidence 11
WARRANTY ONE YEAR WARRANTY REAR VIEW SAFETY, INC. WARRANTS THIS PRODUCT AGAINST MATERIAL DEFECTS FOR A PERIOD OF ONE YEAR FROM DATE OF PURCHASE. WE RESERVE THE RIGHT TO REPAIR OR REPLACE ANY SUCH DEFECTIVE UNIT AT OUR SOLE DISCRETION. REAR VIEW SAFETY, INC. IS NOT RESPONSIBLE FOR A DEFECT IN THE SYSTEM AS A RESULT OF MISUSE, IMPROPER INSTALLATION, DAMAGE OR MISHANDLING OF THE ELECTRONIC COMPONENTS. REAR VIEW SAFETY, INC. IS NOT RESPONSIBLE FOR CONSEQUENTIAL DAMAGES OF ANY KIND. THIS WARRANTY IS VOID IF: DEFECTS IN MATERIALS OR WORKMANSHIP OR DAMAGES RESULT FROM REPAIRS OR ALTERATIONS WHICH HAVE BEEN MADE OR ATTEMPTED BY OTHERS OR THE UNAUTHORIZED USE OF NONCONFORMING PARTS; THE DAMAGE IS DUE TO NORMAL WEAR AND TEAR, THIS DAMAGE IS DUE TO ABUSE, IMPROPER MAINTENANCE, NEGLECT OR ACCIDENT; OR THE DAMAGE IS DUE TO USE OF THE REAR VIEW SAFETY, INC. SYSTEM AFTER PARTIAL FAILURE OR USE WITH IMPROPER ACCESSORIES. WARRANTY PERFORMANCE DURING THE ABOVE WARRANTY PERIOD, SHOULD YOUR REAR VIEW SAFETY PRODUCT EXHIBIT A DEFECT IN MATERIAL OR WORKMANSHIP, SUCH DEFECT WILL BE REPAIRED WHEN THE COMPLETE REAR VIEW SAFETY, INC. PRODUCT IS RETURNED, POSTAGE PREPAID AND INSURED, TO REAR VIEW SAFETY, INC. OTHER THAN THE POSTAGE AND INSURANCE REQUIREMENT, NO CHARGE WILL BE MADE FOR REPAIRS COVERED BY THIS WARRANTY. WARRANTY DISCLAIMERS NO WARRANTY, ORAL OR WRITTEN, EXPRESSED OR IMPLIED, OTHER THE ABOVE WARRANTY IS MADE WITH REGARD TO THIS REAR VIEW SAFETY, INC. REAR VIEW SAFETY, INC. DIS- CLAIMS ANY IMPLIED WARRANTY OR MERCHANT-ABILITY OR FITNESS FOR A PARTICULAR USE OR PURPOSE AND ALL OTHER WARRANTIES IN NO EVENT SHALL REAR VIEW SAFETY. INC. LIABLE FOR ANY INCIDENTAL, SPECIAL, CONSEQUENTIAL, OR PUNITIVE DAMAGES OR FOR ANY COSTS, ATTORNEY FEES, EXPENSES, LOSSES OR DELAYS ALLEGED TO BE AS A CONSEQUENCE OF ANY DAMAGE TO, FAILURE OF, OR DEFECT IN ANY PRODUCT INCLUDING, BUT NOT LIMITED TO, ANY CLAIMS FOR LOSS OF PROFITS. 12 Rear View Safety
DISCLAIMER REAR VIEW SAFETY AND/OR ITS AFFILIATES DOES NOT GUARANTEE OR PROMISE THAT THE USER OF OUR SYSTEMS WILL NOT BE IN/PART OF AN ACCIDENT OR OTHERWISE NOT COLLIDE WITH AN OBJECT AND/OR PERSON. OUR SYSTEMS ARE NOT A SUBSTITUTE FOR CAREFUL AND CAUTIOUS DRIVING OR FOR THE CONSISTENT ADHERENCE TO ALL APPLICABLE TRAFFIC LAWS AND MOTOR VEHICLE SAFETY REGULATIONS. THE REAR VIEW SAFETY PRODUCTS ARE NOT A SUBSTITUTE FOR REARVIEW MIRRORS OR FOR ANY OTHER MOTOR VEHICLE EQUIPMENT MANDATED BY LAW. OUR CAMERA SYSTEMS HAVE A LIMITED FIELD OF VISION AND DO NOT PROVIDE A COMPREHENSIVE VIEW OF THE REAR OR SIDE AREA OF THE VEHICLE. ALWAYS MAKE SURE TO LOOK AROUND YOUR VEHICLE AND USE YOUR MIRRORS TO CONFIRM REARWARD CLEARANCE AND THAT YOUR VEHICLE CAN MANEUVER SAFELY. REAR VIEW SAFETY AND/OR ITS AFFILIATES SHALL HAVE NO RESPONSIBILITY OR LIABILITY FOR DAMAGE AND/OR INJURY RESULTING FROM ACCIDENTS OCCURRING WITH VEHICLES HAVING SOME OF REAR VIEW SAFETY PRODUCTS INSTALLED AND REAR VIEW SAFETY AND/ OR ITS AFFILIATES, THE MANUFACTURER, DISTRIBUTOR AND SELLER SHALL NOT BE LIABLE FOR ANY INJURY, LOSS OR DAMAGE, INCIDENTAL OR CONSEQUENTIAL, ARISING OUT OF THE USE OR INTENDED USE OF THE PRODUCT. IN NO EVENT SHALL REAR VIEW SAFETY AND/OR ITS AFFILIATES HAVE ANY LIABILITY FOR ANY LOSSES (WHETHER DIRECT OR INDIRECT, IN CONTRACT, TORT OR OTHERWISE) INCURRED IN CONNECTION WITH THE SYSTEMS, INCLUDING BUT NOT LIMITED TO DAMAGED PROPERTY, PERSONAL INJURY AND/OR LOSS OF LIFE. NEITHER SHALL REAR VIEW SAFETY AND/OR ITS AFFILIATES HAVE ANY RESPONSIBILITY FOR ANY DECISION, ACTION OR INACTION TAKEN BY ANY PERSON IN RELIANCE ON REAR VIEW SAFETY SYSTEMS, OR FOR ANY DELAYS, INACCURACIES AND/OR ERRORS IN CONNECTION WITH OUR SYSTEMS FUNCTIONS. DISCLAIMER Reverse With Confidence 13
If you have any questions about this product, contact: Rear View Safety, Inc. 1797 Atlantic Avenue Brooklyn, NY 11233 800.764.1028 Better Cameras. Better Service. IT S OUR GUARANTEE. 14 Rear View Safety