Radiomonitoring & Radiolocation Data Sheet 01.03 R&S HF907DC SHF Downconverter Specifications
CONTENTS Definitions... 3 Specifications... 4 Frequency conversion... 4 Input and output properties... 4 Rechargeable battery... 5 Environmental specification... 5 Mechanical specifications... 5 Ordering information... 6 2 Rohde & Schwarz R&S HF907DC SHF Downconverter
Definitions General Product data applies under the following conditions: Three hours storage at ambient temperature followed by 30 minutes warm-up operation Specified environmental conditions met Recommended calibration interval adhered to All internal automatic adjustments performed, if applicable Specifications with limits Represent warranted product performance by means of a range of values for the specified parameter. These specifications are marked with limiting symbols such as <,, >,, ±, or descriptions such as maximum, limit of, minimum. Compliance is ensured by testing or is derived from the design. Test limits are narrowed by guard bands to take into account measurement uncertainties, drift and aging, if applicable. Specifications without limits Represent warranted product performance for the specified parameter. These specifications are not specially marked and represent values with no or negligible deviations from the given value (e.g. dimensions or resolution of a setting parameter). Compliance is ensured by design. Typical data (typ.) Characterizes product performance by means of representative information for the given parameter. When marked with <, > or as a range, it represents the performance met by approximately 80 % of the instruments at production time. Otherwise, it represents the mean value. Nominal values (nom.) Characterize product performance by means of a representative value for the given parameter (e.g. nominal impedance). In contrast to typical data, a statistical evaluation does not take place and the parameter is not tested during production. Measured values (meas.) Characterize expected product performance by means of measurement results gained from individual samples. Uncertainties Represent limits of measurement uncertainty for a given measurand. Uncertainty is defined with a coverage factor of 2 and has been calculated in line with the rules of the Guide to the Expression of Uncertainty in Measurement (GUM), taking into account environmental conditions, aging, wear and tear. Device settings and GUI parameters are indicated as follows: parameter: value. Typical data as well as nominal and measured values are not warranted by Rohde & Schwarz. In line with the 3GPP/3GPP2 standard, chip rates are specified in Mcps (million chips per second), whereas bit rates and symbol rates are specified in Mbps (million bits per second), kbps (thousand bits per second) or ksps (thousand symbols per second), and sample rates are specified in Msample/s (million samples per second). Mcps, kbps, ksps and Msample/s are not SI units. Rohde & Schwarz R&S HF907DC SHF Downconverter 3
Specifications Frequency conversion Conversion Frequency band 1 (BAND 1) ANT IN (input signal) 7.5 GHz to 12.5 GHz IF OUT (output signal) 6.5 GHz to 1.5 GHz Frequency band 2 (BAND 2) ANT IN (input signal) 12.5 GHz to 18 GHz IF OUT (output signal) 7.5 GHz to 2.0 GHz Conversion gain BAND 1 (from ANT IN to IF OUT ) BAND 2 (from ANT IN to IF OUT ) (see Conversion Gain CD for measurement values of the delivered typ. 36 db typ. 34 db see figure 1 device) Input noise level BAND 1 BAND 2 see figure 2 LO signal Frequency accuracy Phase noise Interfering signals Image frequency rejection IF rejection IP3 (output) BAND 1 BAND 2 Input and output properties new equipment (complete temperature range) BAND 1 (LO = 14 GHz) - Offset 10 khz - Offset 100 khz - Offset 1 MHz BAND 2 (LO = 20 GHz) - Offset 10 khz - Offset 100 khz - Offset 1 MHz referred to useful signals with same input level f ANT_IN = f IF_OUT BAND 1: Input signal 40 dbm BAND 2: Input signal 40 dbm 15.4 khz in BAND 1 nom. 22 khz in BAND 2 nom. 64 dbc/hz meas. 96 dbc/hz meas. 122 dbc/hz meas. 62 dbc/hz meas. 95 dbc/hz meas. 120 dbc/hz meas. > 45 db meas. > 45 db meas. > 55 db meas. 10 dbm meas. 16 dbm meas. ANT IN Connector SMA female 50 Ω nom. VSWR < 3.5 meas. Maximal RF input power 17 dbm meas. DC voltage 0 V DC max. IF OUT Connector N female 50 Ω nom. VSWR frequency range 1.5 GHz to 7.5 GHz typ. < 2.5 DC voltage 0 V DC max. 1 db compression BAND 1 BAND 2 6 to 9 dbm meas. 0 to 4 dbm meas. EXT. POWER Connector convenient: DC connector male 6.5 4.3 mm, pin 1.4 mm DC barrel connector male 7 mm / 4 mm / 1.45 mm Voltage range 11 V to 32 V Input power with charged battery while charging battery 7 W meas. 19 W meas. Input current max. 2 A REMOTE Connector 7 pin female (binder series 702) Voltage range for Antenna Bit 0 0 V to 5 V 4 Rohde & Schwarz R&S HF907DC SHF Downconverter
Rechargeable battery Operating time with fully charged battery approx. 12 h meas. BAT.OK off after approx. 6 h meas. Charging time complete empty battery to full battery max. 17 h meas. (with optional external charger approx. 4 h) Voltage 11.25 V nom. Capacity 8850 mah nom. Environmental specification Temperature range Operating temperature range without external power supply 10 C to +50 C Nominal temperature range with external power supply supplied with 0 C to +40 C equipment (order no. 1309.6100.00) Storage temperature range of the battery < 1 month: 20 C to +50 C < 3 month: 20 C to +45 C < 1 year: 20 C to +20 C Damp heat +25 C/+40 C, 95 % rel. humidity, cyclic, in line with EN 60068-2-30 or in line with EN 60068-2-78 +40 C, 95 % rel. humidity, steady state Mechanical resistance Resistance to vibration in line with to DIN EN 60068-2-64 random 10 Hz to 300 Hz: 0.01 g²/hz; 300 Hz to 500 Hz: 0.003 g²/hz; 30 min. in each of the three perpendicular axes; acceleration approx. 1.9 g rms Resistance to shock in line with to DIN EN 60068-2-27 and MIL-STD 810 max. 40 g, transition frequency 45 Hz; in the free perpendicular axes MTBF in line to SN 29500 > 75000 h without battery pack Mechanical specifications Weight HF907DC (battery included) 3.2 kg (7 lb) Dimensions length width height approx. 300 mm (11.81 in) approx. 150 mm (5.90 in) approx. 135 mm (5.31 in) Figure 1: Meas. conversion gain Figure 2: Meas. input noise at ANT_IN (for S/N = 0 db and bandwidth = 1 Hz) Rohde & Schwarz R&S HF907DC SHF Downconverter 5
Ordering information Designation Type Order No. SHF Down Converter R&S HF907DC 4070.8006.03 Recommended extras Receiver R&S PR100 4079.9011.02 Battery Pack R&S HF907DC-BP 4079.3507.02 External Battery Charger R&S HF907DC-CH 4079.3707.02 Cable Set R&S HF907DC K1 4070.8958.02 Tripod Adapter R&S HF907DC Z1 4079.3113.02 Carrying Case R&S HF907DC Z2 4079.3207.02 Broadband Antenna R&S HF907OM 4070.3279.02 6 Rohde & Schwarz R&S HF907DC SHF Downconverter
Rohde & Schwarz R&S HF907DC SHF Downconverter 7
Service that adds value Worldwide Local and personalized Customized and flexible Uncompromising quality Long-term dependability About Rohde & Schwarz The Rohde & Schwarz electronics group offers innovative solutions in the following business fields: test and measurement, broadcast and media, secure communications, cybersecurity, radiomonitoring and radiolocation. Founded more than 80 years ago, the independent company which is headquartered in Munich, Germany, has an extensive sales and service network with locations in more than 70 countries. Sustainable product design Environmental compatibility and eco-footprint Energy efficiency and low emissions Longevity and optimized total cost of ownership Certified Quality Management ISO 9001 Certified Environmental Management ISO 14001 Rohde & Schwarz GmbH & Co. KG www.rohde-schwarz.com Regional contact Europe, Africa, Middle East +49 89 4129 12345 customersupport@rohde-schwarz.com North America 1 888 TEST RSA (1 888 837 87 72) customer.support@rsa.rohde-schwarz.com Latin America +1 410 910 79 88 customersupport.la@rohde-schwarz.com Asia Pacific +65 65 13 04 88 customersupport.asia@rohde-schwarz.com China +86 800 810 82 28 +86 400 650 58 96 customersupport.china@rohde-schwarz.com R&S is a registered trademark of Rohde & Schwarz GmbH & Co. KG Trade names are trademarks of the owners PD 3607.6150.22 Version 01.03 September 2016 (we) R&S HF907DC SHF Downconverter Data without tolerance limits is not binding Subject to change 2016 Rohde & Schwarz GmbH & Co. KG 81671 Munich, Germany 3607.6150.22 01.03 PDP 1 en 3607615022