Using enhanced technology, the AVC63-4 voltage regulator is designed for use on 50/60 Hz brushless generators. This encapsulated regulator is economical, small in size, ruggedly constructed, and incorporates solid state technology with frequency compensation, automatic voltage buildup, overexcitation shutdown, and EM filtering as standard. FEATURES: ntegrated circuitry for compact size, simplicity, high reliability. Extremely rugged. Exciter field current 4A continuous, 7 A forcing. Regulation accuracy better than ± 1.0% no load to full load. Fast response. Frequency compensation. Overexcitation shutdown. EM suppression. Available from stock. CSA approved, File #LR 23131. l Basler Electric CLASS 300 EQUPMENT AVC63 4 VOLTAGE REGULATOR P. 0. BOX 269 HGHLAND, LLNOS 62249, U.S.A. PHONE 618-654-2341 FAX 618-654-2351 FEATURES AND APPLCATONS this page DESCRPTON AND SPECFCATONS page 2 & 3 NTERCONNECT page 3 DMENSONS page 4 NSTRUCTON MANUAL Reference Publication Number 91668 00 998 SVC-1 2-95
:::J DESCRPTON: The AVC63-4 model of voltage regulator maintains generator line voltage on brush less generators from 5 KW to over 100 KW in size. The voltage regulator senses generator average voltage to maintain a precise regulation band within ± 1 percent. This is accomplished by converting a 240 V AC single phase power input to a controlled DC signal to the generator's exciter field. The solid-state voltage build-up circuit will enable automatic generator line voltage build-up with a voltage input to the regulator of at least 6 V AC. Customer accessible stability, underfrequency and range adjusts enable fine tuning of the voltage regulator to the generator in use. <( z 0 z u.. 100 80 0 60 => a.. => 0 a: 0!cc a: w z w CD SPECFCATONS: 40 20 "CORNER FREQUENCY" --T _-[ -T.-- - The over-excitation feature assists in protecting the voltage regulator during an over-excitation fault condition. During this mode, a shutdown signal is sent to the power stage, turning the regulator off. This feature will reset when the voltage input is removed (less than 6 VAC for a minimum of 2 seconds) to the regulator. Figure 1 demonstrates the underfrequency characteristics of the voltage regulator during prime mover low speed conditions. Customer curve selection matches the voltage regulator to 50 or 60 Hz systems. --n. - J- --+- - - =r- 0 ---- 0 10 20 30 40 50 60 70 80 FGURE 1 - DC OUTPUT FREQUENCY (Hz) FREQUENCY COMPENSATON CHARACTERSTC MAX FORCNG MAX. 1 MN MN. CONT. (240 Vac NPUT) OHMS@ AMP VOLT AMP VOLT EXCTER FELD RESSTANCE 25 C MAX. OHMS SENSNG/POWER SNGLE PHASE VOLTAGE RANGE NPUT BURDEN 4 63 7 100 15 100 171-264Vac 500VA 2
SPECFCATONS (continued): DC OUTPUT POWER: 4 Adc at 63 Vdc maximum continuous, 7 Adc at 100 Vdc one minute forcing. (Forcing with 240 Vac nominal input). EXCTER FELD DC RESSTANCE: 15 ohms minimum; 100 ohms maximum. AC SENSNG/POWER NPUT: Operating range: 190-240 Vac single phase, 50/60 Hz ±10%. Burden 500VA. VOLTAGE ADJUST RANGE: 171-264 Vac. REGULATON ACCURACY: Better than ±1.0% no load to full load. RESPONSE TME: Less than 1.5 cycles for ±5% change in sensing voltage. EM SUPPRESSON: nternal electromagnetic interference filtering. OVEREXCTATON SHUTDOWN: Field voltage shuts down after time delay if exciter field voltage exceeds 1 00 Vdc ±5%. The time delay is inversely proportional to the magnitude of the detected overvoltage condition up to F+ F- 3 4 _,_.----A AVC63-4 Hz Hz the 135 Vdc point, thus allowing nominal forcing for approximately 1 minute. Beyond 135 Vdc, the field voltage is removed within 2.0 seconds. VOLTAGE BULDUP: nternal provisions for automatic voltage buildup from generator residual voltages as low as 6 Vac. TERMNATONS: 1/4" "Fast-On" Terminals. POWER DSSPATON: 15 Watts maximum. OPERATNG TEMPERATURE: -40 C (-13 F) to +60 C (+140 F). STORAGE TEMPERATURE: -40 C (-40 F) to +85 C (+ 185 F). VBRATON: Withstands 1.2 Gs at 5 to 26 Hz; 0.036" double amplitude at 27 to 52 Hz; and 5 Gs at 53 to 500 Hz. SHOCK: Withstands up to 15 Gs in each of three mutually perpendicular axes. WEGHT: 8 oz. (0.22 kg) Net. NOTES:.&. FOR 50HZ OPERATON, MOVE JUMPER TO 50HZ TERMNAL. &. FOR REMOTE VOLTAGE ADJUST, USE 1000 OHMS, 1/2 WATT (MN) POT FOR 10% ADJUSTMENT RANGE. ffi USE FAST-BLOW FUSE WTH HGH CURRENT NTERRUPT CAPABLTY. OR 7t-----' nterconnection Diagram, 208/240Vac Nominal. FGURE 2 - TYPCAL NTERCONNECTON DAGRAM 3
4.187 DA. (2 PL) NOTES:.350 (9) VOLTAGE ADJUST 0 STABLTY ADJUST t ===== _l 3.935MAX (100) ---- ------------ -- 2.660 MAX (68) Analog Voltage Controller Model AVC63 4 PN: 91668 00 126 nput 190 240 Vac, 50/60Hz, 500 VA Output 63 Vdc, 4 A U r;::;) Basler Electric @ 9 Highland, llinois USA ---..J 1) DMENSONS ARE N NCHES (MLLMETERS). 2) TERMNALS ARE QUCK-CONNECT TABS.250" x.032". (6.35 x 0.8mm) ON.400" (10.16mm) CENTERS (except 60Hz). ffi DMENSONS TO TERMNALS ARE APPROXMATE. 4) NET WEGHT= 8 OZ (0.22 KG) 5) RECOMMENDED TORQUE LMT ON MOUNTNG HARDWARE: a. #8 screw 8-10 ln-lbs b. M4 screw.9 N-m 6) USE OF LOCKNG NUT WTH NYLON NSERT RECOMMENDED WHEN NSTALLNG AVC WTH LOOSE HARDWARE. UNDERFREQUENCY ADJUST 2.200 MAX (56).181 (TYP.) (5).169 (TYP.) (4) ROUTE 143, BOX 269, HGHLAND, LLNOS U.S.A. 62249 P.A.E. Les Pins, 67319 Wasselonne Cedex FRANCE PHONE 618-654-2341 FAX 618-654-2351 PHONE (33-3-88) 87-1010 FAX (33-3-88) 87-0808 http://www.basler.com, info@basler.com Printed in U.S.A.
Using enhanced technology, the AVC11 0-6 full wave voltage regulator is designed for use on 50/60 Hz brushless generators. This encapsulated regulator is small in size, ruggedly constructed, and incorporates solid state technology with frequency compensation, a build-up circuit, overexcitation shutdown, droop input, accessory input, and EM filtering as standard. FEATURES ntegrated circuitry for compact size, simplicity, high reliability. Extremely rugged. Exciter field current 6A continuous, 1 OA forcing. Regulation accuracy better than ±0.5% no load to full load. Fast response. Frequency compensation. Overexcitation shutdown. EM suppression. Accessory input. ADDTONAL NFORMATON NSTRUCTON MANUAL Request Publication 9317700101 l Basler Electric 1 0 1 AVC110-6 VOLTAGE REGULATOR c N EXCTATON ON/OFF SWTCH (F USED) Figure 1 -Typical nterconnection Diagram 277/480V nominal, 3-phase, 4-wire wye connection P. 0. BOX 269 HGHLAND, LLNOS 62249, U.S.A. PHONE 618-654-2341 FAX 618-654-2351 SVE-1 9-01
AVC11Q-6 SPECFCATONS EXCTER SENSNG DC OUTPUT F ELD RESSTANCE POWER NPUT NPUT MAX FORCNG SNGLE MAX. 10 SEC MN. MAX PHASE VOLTAGE CONT. (240Vac NPUT) OHMS@ OHMS VOLTAGE BURDEN ADJUST AMP VOLT AMP VOLT 25oC 6 110 10 200 DC OUTPUT POWER: 6 Adc at 110 Vdc maximum continuous, 10 Adc at 200 Vdc 10 seconds forcing. (Forcing with 240 Vac nominal input). EXCTER FELD DC RESSTANCE: 18.3 ohms minimum; 100 ohms maximum. AC POWER NPUT: Operating range: 180-277 Vac single phase, 50/60 Hz or 125Hz PMG ±10%. Burden 800VA. SENSNG NPUT: 342-528 Vac single phase, 50/60 Hz ±10% <5VA. VOLTAGE ADJUST RANGE: 342-528 Vac. REGULATON ACCURACY: Better than ±0.5% no load to full load. RESPONSE TME: Less than 1.5 cycles for ±5% change in sensing voltage. EM SUPPRESSON: nternal electromagnetic interference filtering. PARALLEL COMPENSATON: SA <10VA. Adjustable up to 6% droop for 0.8PF. ACCESSORY NPUT: ±3Vdc signal causes a ±30% change in the regulation set point. OVEREXCTATON SHUTDOWN: Field voltage shuts down after time delay if exciter field voltage exceeds a set point adjustable approx. 75-125Vdc. The time delay is inversely proportional to the magnitude of the detected overvoltage condition up to the 240 Vdc point, thus allowing nominal forcing for approximately 10 seconds. Beyond 240 Vdc, the field voltage is removed instantaneously. 18.3 100 RANGE 180-277Vac ±10% 50/60Hz 125Hz PMG 800VA RANGE 342-528Vac 50/60Hz VOLTAGE BULDUP: nternal provisions for automatic voltage buildup from generator residual voltages as low as 5 Vac. TERMNATONS: Screw type. POWER DSSPATON: 35 Watts maximum. OPERATNG TEMPERATURE: -40 C (-40 F) to +60 C (+ 140 F). STORAGE TEMPERATURE: -40 C ( -40 F) to + 70 C ( + 158 F). VBRATON: Withstands 1.5 Gs at 5 to 29 Hz; 0.036" double amplitude at 29 to 52 Hz; and 5 Gs at 52 to 500 Hz. SHOCK: Withstands up to15 Gs in each of three mutually perpendicular axes. WEGHT: 12.58 oz. (0.38 kg) Net. 4.912 (1248) ----1 49 2 - -- 1----4.528 ---- 1( ( 12.5) 1 15.0) 1---- 5512 -- ---1 (140 0) Figure 3 - Outline Drawing (Top view) Basler Electric ROUTE 143, BOX 269, HGHLAND, LLNOS U.S.A. 62249 P.A.E. Les Pins, 67319 Wasselonne Cedex FRANCE PHONE 618-654-2341 FAX 618-654-2351 PHONE (33-3-88) 87-1010 FAX (33-3-88) 87-0808 228 DA HOLE (58) (4 PLACES) http://www. basler. com, i nfo@basler.com 02BJQ.)4 11-02-96 Printed in U.S.A.