Multi Tester Multi Tester Image Model# Features Rapport Mini Professional CCTV Tester Rapport Rapport -10HD/PRO Multi-Format Input Monitor Rapport III / Rapport III-PRO Multi Functional CCTV Tester
MAX Rapport Mini Professional CCTV Tester Rapport SPECIFICATIONS L Rapport mini FEATURES CCTV field monitor controller protocal analyzer Electronic Characteristics Image Operation Test Dimension Input Voltage Battery Built-in Charger Signal System Video In/ Out Protocol Transmission Speed Transmission Mode AC Voltage DC Voltage Resistance Conitinuity 12V ±10%, above 1A 7.4V (3.7x2 )Li-Poly, 2000mAh Charging time More than 6 hrs Operating time More than 6 hrs(max.8hrs) NTSC / 1CH BNC, 1.0-Vpp Multiple 2400 ~ 38400kbps RS-422 / RS-485 4V/ 40V/300V 400mV/4V/40V/300V 400Ω/ 4KΩ /40KΩ /400K Built-in Buzzer sound 79.1(W) x 159.3(H) x 32.2(D) mm RAPPORT Mini DIMENSIONS Unit : mm CCTV Field Monitor COLORBAR CLR The Rapport Mini features color CCTV field monitor. It built-in 2.5 inch color Digital Type TFT-LCD monitor, supports both & NTSC video signal format. Display video signal level (IRE) is helpful to check the video quality. Brightness & Contrast control. 63.8 PWR CHG 66.5 Tx Rx 79.1 32.2 Controller 159.3 FAR OPEN SET TELE OSD ADDR : 0 PROTOCOL : () PELCO-D BAUDRATE : 19.2Kbps PARITY : NON SPD GPST SPST FUNC MENU 15 0 0 SETUP DATA The Rapport Mini features full function of CCTV Controller. It controls & programs variety of Speed & Slow Dome cameras. This will allow CCTV installer to test or program cameras at the actual camera job site. It has multi protocol and programmable baud rate. NEAR CLOSE ~ V 300V 300V~ WIDE ~ COM V/ METER DC AC OHM VOLT BUZZ DCV -0.000V Rapport Mini features Digital multimeter. It combines the most basic instrument include a voltmeter, ohmmeter and continuity tester. DCV--0.0V STORE Protocol Analyzer Receive Data 04 3F 3F 8B 04 3F 3F 8B 04 3F 3F 8B 00 00 00 09 The Rapport Mini features Protocol Analyzer. It determines which protocol to control you cameras from Controller or DVR. This will guide CCTV installer to understand the protocol and find the fault device easily. CLEAR
RAPPORT-10HD Rapport -10HD/PRO Multi-Format Input Monitor Support Full HD Suitable for HD CCTV monitor in limited space and field monitor as well. 10.05", 16:9 widescreen aspect ratio without the quality loss than comes from scaling, altering an image to fit on a different screen size Superb connectivity with various surveillance equipments and peripherals with the HD-SDI, CVBS, VGA ports. And the HDMI port also gives uncompressed high quality video. White LED backlight ensures natural colors from camera, DVR or others. VESA standard 4 holes on the back allows placing in car window or mounting to a wall. Dust protection optical bonding glass with AR/AG coating. Li-ion Polymer battery with 5000mA capacity runs 4 to 6 hours with battery. User-friendly GUI and intuitive and stylishly designed touch controls on the top of the sturdy aluminum case. USB port prepared for firmware update in case debugging or performance enhancement. FEATURES Built-in 10.05" High resolution LCD Multi Format Video Input HDMI, HD-SDI, VGA, CVBS Auto detection input video formats 100% Digital Processing White LED BacklightV 4:3 and 16:9 screen aspect ratios User friendly GUI(Grapic user interface) Li-ion Polymer Battery with 5000 mah capacity Runs 4 to 6 hours with Battery Optical Bonding Glass with AR/AG coating (Dust Protection) VESA standard 4 holes on the back Mount for in-car System Flush Type Stand Aluminum frame Power supply included SPECIFICATIONS L Electronic characteristics LCD Storage Storage File System Recording File Format AUDIO Size Current consumption Battery Built-in battery HD-SDI CVBS HDMI VGA LCD SD/SDHC FAT DIMENSIONS 266 266 Rapport -10HD 1600mA (DC 12V ± 15% ) Li-ion Polymer Battery, 5000mAh/7.4V (Built-in) Charging 8hours (charge only) time 10hours (Working) Operating 4~5 hours 10p 24,25,30 10i 50, 60 720p 50,60 NTSC / 10p 24,25,30 10i 50, 60 720p 50,60 480i, 576p 576i, 576p 1280x1024 60,75 1280x960 60,85 1152x864 75 1024x768 60,70,75,85 800x600 60,72,75,85 10.05, 1280x800 RGB. Default. SANDISK 32GB (Class 10) FAT16, FAT32 (Recommended) AVI (H.264) AUDIO Only HD-SDI & HDMI ( Support 48KHz,16bit audio bandwidth) Speaker 8 ohms 0.5W (Audio OUT) Phone jack 3.5inch Stereo (Audio OUT) 266(W) x 176(H) x 38(D) 176 Unit : mm 38
The multi format input monitor, which is the best for office demo, HD SDI camera test and evaluation, customer demo and exhibition or field monitor for installation of the HD SDI camera. HD-SDI HDMI VGA CVBS HD-SDI Multi-Format Input HDMI HD-SDI CVBS HDMI VGA RAPPORT-10HD VGA CVBS All information of the camera come in sight The video input, power connection and audio input etc, kinds of video connected inforations are shown by the OSD (On Screen Display). RAPPORT-10HD PRO, Support DVR function < Rapport-10HD > REC button < Rapport-10HD PRO> [ Recording ] [ Recorded files ] A handy OSD menu In the OSD menu, display setting, adjust audio volume, system of the product, and also possible to upgrade of the new firmware in the system. 1 2 3 4 5 6 7 8 Adjust brightness of LCD screen Adjust video display position Set the Audio singal (only HD-SDI, HDMI) Set the product system and firmware upgrade Select OSD display Power LED Indicate charging status Power ON/O button. Selection menu Move and select menu. MENU button button REC button
Rapport III / Rapport III-PRO Multi Functional CCTV Tester SPECIFICATIONS L Rapport III / Rapport III-PRO RAPPORT-III FEATURES Color CCTV Field Monitor Video Signal Generator Protocol Analyzer Digital Multi Meter Test & Measure Voltage, Resistance and Continuity UTP Cable Tester Test for Direct & Cross cable, continuity, discontinuity and Shorts on UTP cable Video Recorder Controller Control for cameras (Pan, Tilt, Zoom and menu Setup). And also analyzing control protocol if camera control by external device. DVR Mode (Rapport III-PRO only) MPEG4 Digital Video Recorder allows users to store video inputs on a SD card for future playback (Max. 10mins / 8files) Input Voltage Electronic Battery Characteristics Built-in Charger Signal System Image Video Level Protocol Operation Transmission Speed Test Transmission Mode UTP Cable Tester Tests AC Voltage DC Voltage Resistance Conitinuity Dimension PART DETAILS BNC Video Input 12V ±10%, above 1.2A Lithium Polymer Battery (Inner Packaging) Charging time More than 6 hrs Operating time More than 6 hrs(max.8hrs) NTSC / 1.0Vp-p, 140 IRE Multiple 2400 ~ 115.2kbps RS-422 / RS-485 Continuity / Crossed Cable, and Breaks or Short Circuits Max. 300V Max. 300V Max. 40 Beeper is activated when the resistance is below 80Ω (W) x 126(H) x 40(D) mm BNC Video Output UTP Input RS-485 In/Out DIMENSIONS SD Card Slot LED Indicator 126 Control Pad Power Input DC12V 40 Test Lead Port Main Power Switch Unit : mm
Rapport III / Rapport III-PRO Multi Functional CCTV Tester NTSC IRE: C B COLOR BAR 07 BRIGHT CONTRAST COLORBAR CLR 07 The Rapport III features a color CCTV field monitor. FORMAT CLR Its built-in 3.5 inch color Digital Type TFT-LCD monitor, supports both & NTSC video signal format. Display video signal level (IRE) is helpful to check the video quality. Brightness & Contrast control. DCV -0.000V The Rapport III features a Video signal generator. SPD 15 GPST 0 It combines the most basic instruments including a voltmeter, ohmmeter and continuity tester. UTP Cable tester CABLE Receive Data SPST FUNC MENU 0 SETUP DATA The Rapport III features full function of CCTV Controller. It controls & programs a variety of Speed & Slow Dome cameras. This will allow the CCTV installer to test or program cameras at the actual camera job site. It has multi protocol and a programmable baud rate. STORE Protocol Analyzer ADDR : 0 PROTOCOL : () PELCO-D BAUDRATE : 19.2Kbps : NON PARITY Rapport III features a Digital multimeter. DCV--0.0V Its outputs Color bar, Red, Blue and Green screen to allow technician to inspect video monitor or DVR. Supports both & NTSC video signal format. Controller OHM VOLT BUZZ METER DC AC OmV NO CONNECTION 04 04 04 00 3F 3F 3F 3F 3F 3F 00 00 CLEAR 8B 8B 8B 09 (1) XXXXX (X) (2) XXXXX (x) (3) XXXXX (X) (4) XXXXX (X) The Rapport III features Protocol Analyzer. (5) XXXXX (X) (6) XXXXX (x) (7) XXXXX (X) (8) XXXXX (X) TEST It determines which protocol to control you cameras from Controller or DVR. This will guide CCTV installer to understand the protocol and find the faulty device easily. Rapport III features a UTP Cable Tester. It s specified to quickly test a wire's comtinuity, miswiring and polarization in your network by using an attached remote terminator so you can easily test the cable whether before or after the cable is installed. Digital Video Recorder (Rapport III-PRO) COLORBAR CLR Rapport III features a portable DVR function. The Rapport III-PRO has a built-in MPEG4 Digital Video Recorder. It allows users to store video inputs on a SD card for future playback. This ensures proper CCTV installations. DISCONTINUED PRODUCTS Rapport 337 Rapport II / Rapport II-PRO 126 11990 Rapport 337 40 RAPPORT-III Video signal generator CCTV Field Monitor