C- DSP-090 GUIDE TO SYSTEM CONNECTION NTUL SOUND DIGITL SOUND FIE POCESSG MPLIFIE DSP 090 CEM DSP POWE POCESSO C PO LOGIC DSP DIGITL SOUCE C PCM PUT SELECTO VOLUME PUT TIM SET MENU POGM EFFECT PUT MODE VC TUNE PHONES VIDEO UX BSS BSS TEBLE BLNCE EXTENSION S VIDEO VIDEO L UDIO SOUCE VC PHONO VIDEO UX VIDEO UX Set Up The Speakers Before Making Connections Place the Front Effect Speakers further apart from the Main Speakers, on either side of and a few feet behind and above the Main Speakers. If you will use a Subwoofer such as a Yamaha ctive Servo Subwoofer System, the position of the subwoofer is not so critical because low bass tones are not highly directional. Place the Main Speakers in the normal position. Place the Center Speaker precisely between the two Main Speakers. Place the ear Effect Speakers behind your listening position. They should be nearly six feet up from the floor. Main speaker Effect speaker Center speaker
CONNECTG SPEKES Main Speaker Main Speaker L ear Speaker ear Speaker L UDIO SIGNL UDIO SIGNL VIDEO SIGNL SPEKES VIDEO S VIDEO M CENTE B O + B O B VC 8ΩM./SPEKE E + B: ΩM./SPEKE O B: 8ΩM./SPEKE E C LETS SWITCHED 8ΩM./SPEKE 8ΩM./SPEKE E CN BE USED S ND, IF SELECTED ON OFF M PE M M CH E CENTE WOOFE EFFECT I0V 60Hz I0W MX. TOTL Front Effect Speaker Front Effect Speaker L Connect bare ends of speaker wires to terminals or use Banana Plugs ed: positive (+) Black: negative ( ) ➀ Unscrew the knob. ➁ Insert the bare wire. ➂ Tighten the knob and secure the wire.
POWE HIGH CUT VOLUME 0 Hz 0 Hz 0 0 POWE HIGH CUT VOLUME 0 Hz 0 Hz 0 0 POWE HIGH CUT VOLUME 0 Hz 0 Hz 0 0 CENTE SPEKE(S) To Use One Center Speaker SPEKES CENTE B To Use Two Center Speakers SPEKES CENTE B Set to + B. + B O B + B O B + B: ΩM./SPEKE O B: 8ΩM./SPEKE + B: ΩM./SPEKE O B: 8ΩM./SPEKE Set to O B. UNSWITCHED I0V 60Hz I80W MX. WOOFE To Use One Subwoofer System To Use Two Subwoofer Systems WOOFE WOOFE L VV500
CONNECTG VIDEO COMPONENTS udio Connections DIGITL Player TV/Satellite Tuner Video Cassette ecorder C-F DIGITL L L L L C F SIGNL GND UDIO SIGNL UDIO SIGNL VIDEO SIGNL SPEKES VIDEO S VIDEO M CENTE B PHONO COXIL OPTICL TUNE VC ON OFF M 8ΩM./SPEKE 8ΩM./SPEKE E VC /DVD DIGITL SIGNL CN BE USED S ND, IF SELECTED PE M M CH F CENTE WOOFE L L L L DIGITL Video Cassette ecorder or nother Video Component Video Cassette ecorder 6
Notes If your components are equipped with digital audio signal output (and input) jacks, they can be connected to this unit s DIGITL SIGNL input (and output) jacks. Even if you connect a component to the DIGITL SIGNL jack of this unit, you must keep the component connected with the same named analog audio signal jacks of this unit, because digital signal cannot be recorded by a tape deck or VC other than the tape deck connected to the OPTICL jack of this unit. If your player has an C- F signal output jack, connect it to this unit s C- F SIGNL input jack. udio signals encoded with the Dolby Surround C- are input to this unit by this connection. (General Model) + B O B + B: ΩM./SPEKE O B: 8ΩM./SPEKE To C Outlet VOLTGE SELECTO C LETS SWITCHED UNSWITCHED 8ΩM./SPEKE ONT E I00W MX. TOTL 00W MX. EFFECT : C Pin Plug Connector Cable (ed): ight udio (White): Left udio : Optical Fiber Cable : Basic Connection (equired) : dditional Connection For Higher Sound Quality Or Special Performance 7
Video Connections If your video components offer S-Video capability, they can be connected to this unit s S VIDEO jacks. Otherwise, connect the composite video input/output jacks of your video components to this unit s composite VIDEO input/output jacks. Video Cassette ecorder Player TV/Satellite Tuner C F SIGNL GND UDIO SIGNL UDIO SIGNL VIDEO SIGNL SPEKES VIDEO S VIDEO M PHONO COXIL OPTICL TUNE VC ON OFF M 8ΩM./SPEKE 8ΩM./SPEKE VC /DVD DIGITL SIGNL CN BE USED S ND, IF SELECTED PE M M CH CEN S-VIDEO VIDEO VIDEO S-VIDEO VIDEO S-VIDEO VIDEO S-VIDEO VIDEO S-VIDEO S-VIDEO VIDEO VIDEO S-VIDEO VIDEO S-VIDEO VIDEO S-VIDEO Video Cassette ecorder or nother Video Component Monitor TV Video Cassette ecorder Note If you wish to connect a second monitor TV (or a projector) to this unit, you can switch the VIDEO jack (and S VIDEO jack also) to a second monitor out jack for the connection with another monitor TV. (See page of the Owner s Manual for details.) (Yellow) : C Pin Plug Connector Video Cable : S-Video Cable Second Monitor TV CN BE USED S ND, IF SELECTED VIDEO : Composite VIDEO Connection : S-VIDEO Connection S-VIDEO
CONNECTG UDIO COMPONENTS Turntable OPTICL DIGITL COXIL DIGITL Player Tuner GND L L L C F SIGNL GND UDIO SIGNL UDIO SIGNL VIDEO SIGNL SPEKES VIDEO S VIDEO M PHONO or COXIL OPTICL TUNE VC ON OFF M 8ΩM./SPEKE 8ΩM./SPEKE VC /DVD DIGITL SIGNL CN BE USED S ND, IF SELECTED PE M M CH CEN L L L L Tape Deck DIGITL DIGITL Tape Deck (DT)
Settings Of Switches On The ear Panel M Switch Normally set to 0 db. If desired, you can decrease the mainchannel output level at the M speaker terminals by 0 db by setting this switch to 0 db. ON OFF M PE M M CH Switch Set to OFF () when setting up a full 7 or 6 speaker system, or to ON () when setting up a 5 or speaker system. PL/NTSC Switch (General Model Only) Set this switch to the position corresponding to the video format that your video equipment employs. Connecting External Power mplifier(s) If you wish to use an external power amplifier to drive speakers for any channel, connect the power amplifier to the corresponding line-level output jacks of this unit. Main Speakers L L Front Effect Speakers Power mplifier Power mplifier 8ΩM./SPEKE 8ΩM./SPEKE M PE M M CH E CENTE WOOFE EFFECT Power mplifier Monaural Power mplifier Monaural Power mplifier L Center Speaker Center Speaker ear Effect Speakers 5