Owner s Guide Model L32C205 32 Class (31.51 Diagonal) Thank you for purchasing this Hitachi product. Please read these instructions carefully. For additional assistance please call 1-888-333-1899(U.S.A. or Puerto Rico), or 01-800-700-4321(Mexico) or visit our website at www.hitachi.us/tv. Keep this owner s guide for future reference. Record the model number and serial number of your LCD Television for future reference. This information is located on the back of the television. MODEL NUMBER SERIAL NUMBER TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS... 2-6 HOW TO ATTACH / REMOVE THE STAND... 7 FIRST TIME USE... 10-13 TV OPERATION... 14-18 CONNECTIONS TO OTHER EQUIPMENT... 19-21 TROUBLESHOOTING... 22 SPECIFICATIONS... 23 LIMITED WARRANTY... 24-25 END USER LICENCE AGREEMENT FOR HITACHI DTV SOFTWARE...26-27 APPENDIXES... 28 L32C205_OR-OG_cover.indd 6 7/5/11 3:03:36 PM
SAFETY PRECAUTIONS The unit emits heat when in operation. Do not place any covers or blankets on the unit, this may cause overheating. Do not block ventilation holes, or set up near radiators. Do not place in direct sunlight. When placing on a shelf leave 4 inches (10 cm) free space around the entire unit. 4 inches 4 inches Notes when mounting the LCD TV on a wall If the unit is to be mounted on the wall, contact the retailer where you purchased the LCD TV for advice, and have the equipment professionally installed. Incomplete or improper installation may cause injury to you, and/or damage to the LCD TV. The screws ISO M6 thread type should be used. The insertion length must be within 12-16mm. If the insertion length is less than 12mm, the weight can not be maintained. If the insertion length is more than 16mm, a space is created between the Wall Mount Bracket and the Television. (Insertion Length) = (Screw Length) - (Washers Thickness) - (Mounting Bracket Thickness) Securing to a Wall 1. Use metallic wire, clamp and screw (not provided) on the rear of the LCD TV as shown below. 2. Use proper hardware (drywall anchor, masonry screw, etc) to secure other end of wire to wall. Wire 4 inches Wire Clamp Screw M6 12 NOTICE FOR TV CABINET If the unit is to be mounted on a cabinet smaller than the length of the unit, it could result in an unstable location and the unit may tumble over, making a risk of personal, possibly fatal injury. Also, this would damage the product seriously. Accordingly, Hitachi accepts no responsibility or liability for any injuries or property damage resulting from the improper installation. YES YES!! NO!!
The below figures are for reference only,please refer to the actual units to determine the appearances. Every hole of the pedestal must be fastened with screws! 1.Lay the soft cloth on a table which can hold the weight of the whole TV. 2.Put the TV on the cloth with its back upwards and the LCD downwards. 3.Take out the pedestal,and insert the pedestal into the TV then put the pedestal,to relevant position of the TV set,until all the holes match each other completely. 4. Fasten the pedestal and the TV set together with screws. 5. Erect the TV set,and put it on the proper position for watching. above
End User License Agreement
POWER COMPONENT
Antenna connections If you are using an indoor or outdoor antenna, follow the instructions below that correspond to your antenna system. If you are using a Cable TV service, see Cable TV connections. Combination VHF/UHF Antenna (Single 75 ohm cable) Antenna Jack 75 ohm Coaxial Cable Cable TV connections This TV has an extended tuning range and can tune most cable channels without using a Cable TV Converter box. Some cable companies offer premium pay channels where the signal is scrambled. Descrambling these signals for normal viewing requires the use of a descrambler device which is generally provided by the Cable TV company. For subscribers to basic Cable TV service Antenna Jack For basic Cable TV service not requiring a Converter/Descrambler box, connect the 75 ohm Coaxial Cable directly to the Antenna Jack on the back of the TV. 75 ohm Coaxial Cable For subscribers to scrambled Cable TV service If you subscribe to a Cable TV service which requires the use of a Converter/Descrambler box, connect the incoming 75 ohm Coaxial Cable to the Converter/Descrambler box. Using another 75 ohm Coaxial Cable, connect the output jack of the Converter/Descrambler box to the Antenna Jack on the TV. Follow the connections shown below. Set the TV to the output channel of the Converter/ Descrambler box (usually channel 3 or 4) and use the Converter/Descrambler box to select channels. Incoming 75 ohm Cable TV Cable Converter/ Descrambler 75 ohm Cable to TV Antenna Jack For subscribers to unscrambled Cable TV service with scrambled premium channels If you subscribe to a Cable TV service in which basic channels are unscrambled and premium channels require the use of a Converter/Descrambler box, you may wish to use a signal Splitter and an A/B Switch box (available from the Cable TV company or an electronics supply store). Follow the connections shown below. With the switch in the B position, you can directly tune any nonscrambled channels on your TV. With the switch in the A position, tune your TV to the output of the Converter/Descrambler box (usually channel 3 or 4) and use the Converter/Descrambler box to tune scrambled channels. Incoming 75 ohm Cable TV Cable Splitter Converter/ Descrambler A/B Switch A B 75 ohm Cable to TV Antenna Jack
Starting setup will assist you to specify the Air/Cable setting and program your channels automatically. IMPORTANT: Make sure that the antenna or cable TV system connection is made. 1 To turn on the TV, touch POWER (POWER indicator on the front of the unit changes blue. It may take approx. 10 seconds for a picture to appear on screen.). The Setup Wizard function begins. Setup Wizard Please select your tuner mode: Air Cable Tuner Move SEL Select Return 2 Press or to select Source, then press or to select Cable or Air. TO SELECT DIGITAL CHANNELS button followed by the remaining number. Example, to select channel 15-1, press 1, 5,, 1, then press SELECT. If a channel is selected with only audio content, Audio only will be displayed on the screen. If a channel is selected with a weak digital signal, Weak Signal or Channel not available. will be displayed on the screen. The same program may be available on either an analog channel or a digital channel. You may choose to watch either format. If a channel is selected to which you have not subscribed, Scrambled will be displayed on the screen. VHF/UHF/CABLE CHANNELS Air VHF 2-13 UHF 14-69 Cable VHF 2-13 CATV 1-125 Digital Terrestrial Broadcast(8VSB):2-69 Digital cable(64/256 QAM):1-135 ENGLISH 3 Press or to select Scan, then press or SELECT. Setup Wizard will begin. After the Setup Wizard is 4 completed, the TV channel appears on the screen. Depending on the reception condition, it may take up to 25 minutes or more to complete memorizing digital cable channels. Please allow the process to complete without interruption. NOTE If you press EXIT in the process of Setup Wizard, the Setup Wizard stops and changes to the normal screen. When you make a menu selection, your changes occur immediately. You do not have to press EXIT to see your changes. TV operation 1 To turn on the TV, press POWER. (POWER indicator on the front of the unit changes blue. It may take approx. 10 seconds for a picture to appear on screen.) 2 Adjust the volume level by pressing VOL or. The volume level will be indicated on the screen by volume bars. As the volume level increases, so do the number of bars. If the volume decreases, the number of volume bars also decreases. 3 Set the Source option to the appropriate position. 4 Press the Direct Channel Selection (0-9, ) buttons to select the channel. (If you press only the channel number, channel selection will be delayed for a few seconds.) TO SELECT ANALOG CHANNELS 1-9: Press 1-9 as needed. Example, to select channel 2, press 2, then press SELECT. 10-99: Press the 2 digits in order. Example, to select channel 12, press 1, 2, then press SELECT. 100-135: Press the 3 digits in order. Example, to select channel 120, press 1, 2, 0, then press SELECT. NOTES If a channel with no broadcast is selected, the sound will automatically be muted. It may take a few seconds for a digital channel picture to appear on screen after being selected. To select the video input source To view a signal from another device connected to your LCD TV, such as a VCR player, press INPUT, then press or, then press SELECT.You can select TV, Video, Component, HDMI or RGB depending on which input jacks you used to connect your devices. TV AV Component RGB HDMI 1 HDMI 2 SEL Select Input Move MENU Return CH / Press and release CH /. The channel automatically stops at the next channel set into memory. For proper operation, before selecting channels, they should be set into the memory. Refer to the Channels Menu on page 14.
EXIT EXIT EXIT EXIT
Aspect Ratio EXIT EXIT EXIT EXIT
RGB ( "PC Standby" being only available in RGB input.)
To connect a HDMI or a DVI device to the unit The HDMI/DVI input receives digital audio and uncompressed video from a HDMI device or uncompressed digital video from a DVI device. When you connect to a DVI device with a HDMI-to-DVI adapter cable, it transfers only video signal. Separate analog audio cables are required. Back of the unit RGB/DVI AUDIO Input Audio cord (not supplied) To DVI output DVI device HDMI - to - DVI adapter cable (HDMI type A connector) (not supplied) To HDMI/DVI IN or HDMI cable (type A connector) (not supplied) To HDMI out HDMI device When using a HDMI input from a Set-Top-Box, it is recommended to use a 1080p, 1080i or 720p input signal. When the HDMI input is a 1080p signal, it is recommended that the length of the cable should be less than 5 meters.
31.51 184 48.6 21.5 7.2 1.9 0.8
Limited Warranty LIMITED WARRANTY TO ORIGINAL CONSUMER LCD TV Up to 32 : Carry-in or ship-in service only Above 32 : In-home service Subject to the terms and conditions of this Limited Warranty (this Warranty ), this Hitachi Television Product, including any accessories included in the packaging) (this Product ), is warranted by Hitachi America, Ltd. ( Hitachi ) to the original consumer purchaser against defects in materials and workmanship as follows: 1. LABOR: For a period of one year from date of original consumer purchase, if this Product or any functional part is determined by Hitachi, or any authorized servicer specified by Hitachi ( Authorized Servicer ), to be defective, Hitachi will repair the Product or, at Hitachi s option, replace the Product with a Hitachi refurbished television product of similar or better quality, at no charge to the original consumer. After the expiration of the one year Warranty period, consumer is responsible for all repairs and repair-related labor charges. 2. PARTS: For a period of one year from the date of original consumer purchase, Hitachi will supply, at no charge to the original consumer new, rebuilt, or refurbished functional replacement parts in exchange for defective parts. After the expiration of the one year Warranty period, consumer is responsible for the costs of all parts. 3. TRANSPORTATION: Except to the extent the Product qualifies for in-home service, customer assumes responsibility for all applicable transportation or shipping charges related to delivering Product to an Authorized Servicer during the aforementioned warranty period; provided that, if Product is shipped to an Authorized Servicer by customer, Hitachi will pay the cost of shipping the Product back to the consumer. Product 32 or below is not eligible for in-home service. 4. IN-HOME SERVICE: In-home service requires clear, complete and easy access to the Product by the Authorized Servicer and does not include removal or re-installation of an installed Product. It is possible that certain in-home repairs will not be completed on-site, but will require that the Product or parts of the Product, at the Authorized Servicer s discretion be removed for shop diagnosis and/or repair. The Product or parts will then be returned to the consumer. To obtain Warranty Service and Troubleshooting information: Call our Electronics Consumer Care Center at 1-888-333-1899(U.S.A. or Puerto Rico), or 01-800-700-4321(Mexico).. Hours: 9am to 6 pm EST Monday Friday (excluding holidays) To receive Warranty service, the original consumer purchaser must contact Hitachi at the above telephone number for problem determination and service procedures. Proof of purchase in the form of an original bill of sale or receipted invoice, evidencing that the Product is within the applicable Warranty period(s), MUST be presented to Hitachi, or an Authorized Servicer, in order to obtain the requested service. Exclusions and Limitations: This Warranty covers manufacturing defects in materials and workmanship encountered in the normal, noncommercial use of the Product, and does not cover consumer instruction, delivery, installation, set-up, adjustments, signal reception problems (including antenna), cosmetic damage or damage due to acts of nature, accident, misuse, abuse, negligence, commercial use or modification of, or to any part of the Product. In addition, this Warranty does not cover ghosting or image retention the Product s screen caused by extended and/or repeated display of fixed on-screen content. This Warranty applies to the original consumer only and does not cover Products sold to consumers in used, AS IS or WITH ALL FAULTS condition, or consumables (e.g., fuses, batteries, bulbs etc.), and the Warranty is invalid if the factory-applied serial number has been altered or removed from the Product. Damage occurring to any Product returned for service that is caused by improper or unsecure packaging or shipping by the original consumer purchaser is excluded from coverage under this Warranty. This Warranty is valid only in the United States and Puerto Rico, and only applies to Products purchased and serviced in the United
Limited Warranty States and Puerto Rico. Warranty will be voided if attempts of repair are performed by the consumer or any servicers that are NOT authorized by Hitachi. THERE ARE NO EXPRESS WARRANTIES OTHER THAN THOSE EXPRESSLY DESCRIBED ABOVE, AND NO WARRANTIES WHETHER EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, SHALL APPLY AFTER THE EXPRESS WARRANTY PERIOD STATED ABOVE, AND NO OTHER EXPRESS WARRANTY OR GUARANTY GIVEN BY ANY PERSON, FIRM OR ENTITY WITH RESPECT TO THE PRODUCT SHALL BE BINDING ON HITACHI. THIS WARRANTY IS THE EXCLUSIVE WARRANTY WITH RESPECT TO THE PRODUCT AND HITACHI IS THE EXCLUSIVE WARRANTY PROVIDER FOR THE PRODUCT. REPAIR OR REPLACEMENT IS THE EXCLUSIVE REMEDY OF THE CONSUMER. HITACHI SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES CAUSED BY THE USE, MISUSE OR INABILITY TO USE THE PRODUCT. NOTWITHSTANDING THE FOREGOING, CONSUMER S RECOVERY AGAINST HITACHI SHALL NOT EXCEED THE PURCHASE PRICE OF THE PRODUCT SOLD BY HITACHI. THIS WARRANTY SHALL NOT EXTEND TO ANYONE OTHER THAN THE ORIGINAL CONSUMER WHO PURCHASED THE PRODUCT AND IS NOT TRANSFERABLE. Some states do not allow the exclusion or limitation of incidental or consequential damages, or allow limitations on warranties, so the above limitations or exclusions may not apply to you. This Warranty gives you specific rights, and you may have other rights, which vary from state to state. CUSTOMER RECORD (Please Retain for your records) Date of Purchase: Store/Dealer: Model No.: Serial No.: Important: Keep all original Product packaging materials and the original receipt in the event Product needs service.