OPTOTRONIC Intelligent

Transcription

1 OPTOTRONIC Intelligent Compact constant current LED drivers Dimmable DALI Areas of application _ Installation in emergency lighting systems according to IEC , appendix J _ Suitable for use in luminaires with flexible current setting (DALI, CLO, LEDset) _ Suitable for indoor SELV installations _ Suitable for luminaires of protection classes I and II _ Suitable for downlights, spotlights and LED panels _ Installation via Cable Clamp Kit possible (depending on version of product) Product benefits _ Versatile DALI window driver due to flexible output characteristic _ Very high efficiency and reliability _ Protection of the system thanks to thermal management and Smart Control _ High-quality dimming of % by amplitude dimming _ Soft switch off function (OTi DALI 15) Versatile scope of application due to OSRAM DALI Technology: _ Easy to use in corridors and restrooms because of three-level Corridor function _ Touch DIM application: easy to control via pushbutton or sensor _ Energy efficient Touch DIM operation due to automatic switch-off at sufficient residual light _ Suitable for emergency Installations (acc. to EN and IEC , appendix J) thanks to DC detection (0 Hz, pulsating DC), on/off switchable _ Feedback of power consumption and operating hours (Fit for SMART GRID) _ Suitable for buildings according to EPBD/BREEAM/LEED due to automatic Constant Lumen Output setting Product features _ Supply voltage: V _ Line frequency: 0 Hz 50 Hz 60 Hz _ Line voltage: V _ Safety according to EN , , , OPTOTRONIC Intelligent Page 1 of 10

2 _ Prepared for DALI-2 certification (Part -101,-102 and -207) _ RI suppression according to EN 55015:2007+A1:2007/CDN _ Line harmonics according to EN _ Immunity according to EN _ Lifetime: up to 100,000 h (temperature at Tc = 65 C, max. 10 % failure rate) _ Type of protection: IP20 _ Independent connection via through-looping (except OTi DALI 15) OPTOTRONIC Intelligent Page 2 of 10

3 Technical data Electrical data Nominal voltage Mains frequency Input voltage AC Input voltage DC Total harmonic distortion V Hz V 1) V < 10 % V Hz V 1) V < 20 % > V Hz V 1) V < 20 % > V Hz V 1) V < 10 % > 0.95 ECG efficiency Device power loss Power loss in stand-by mode Inrush current Max. ECG no. on circuit breaker 10 A (B) 88 % 2) 2.4 W 0.27 W 5 A 3) % 2) 4.5 W <0.1 W < 20 A 7) % 2) 5.7 W <0.1 W < 20 A 7) % 10) 7.5 W <0.15 W 30 A 11) Max. ECG no. on circuit breaker 16 A (B) Power factor λ Max. ECG no. on circuit breaker 25 A (B) Surge capability (L/N- Ground) Nominal output voltage - 1 kv V 4) 60 V - 1 kv V 4) 60 V - 2 kv V 4) 60 V - 2 kv 12) V 4) 60 V U-OUT (working voltage) Nominal output current ma 5) ma 5) ma 5) ma 5) Output current tolerance Output ripple current (100 Hz) Nominal output power ±3 % < 2 % 18 W 6) ±3 % < 1 % 27 W 8) ±3 % < 2 % 35 W 9) ±3 % < 2 % 55 W 13) Galvanic isolation Surge capability (L- N) SELV SELV 1 kv SELV 1 kv SELV 1 kv 1) Permitted voltage range 2) Typical 3) twidth = 45 µs (measured at 50 % I peak ) 4) Maximum 60 V OPTOTRONIC Intelligent Page 3 of 10

4 5) ±5% 6) Partial load 3 18 W 7) twidth = 50 µs (measured at 50 % I peak ) 8) Partial load 7 27 W 9) Partial load W 10) At full load and 230 V 11) twidth = 200 µs (measured at 50 % I peak ) 12) Functional Earth 13) Partial load W Dimensions & weight Length Width Height Product weight Cable crosssection, input side 95.0 mm 53.0 mm 30.0 mm g mm² 1) mm 67.0 mm 29.5 mm g mm² 1) mm 67.0 mm 29.5 mm g mm² 1) mm 75.0 mm 25.0 mm g mm² 1) Cable crosssection, output side Wire preparation length, input side Wire preparation length, output side mm² 1) mm mm Mounting hole spacing, length Mounting hole spacing, width mm² 1) mm mm 94.0 mm 58.0 mm mm² 1) mm mm 94.0 mm 58.0 mm mm² 1) mm mm 99.0 mm 64.0 mm 1) Solid or flexible leads OPTOTRONIC Intelligent Page 4 of 10

5 Product line drawing OPTOTRONIC Intelligent Page 5 of 10

6 Colors & materials Casing material Plastic Plastic Plastic Plastic Temperatures & operating conditions Ambient temperature range Maximum temperature at tc test point Max.housing temperature in case of fault C 75 C 1) 100 C 5 85 % 2) C 75 C 1) 110 C 5 85 % 2) C 75 C 1) 110 C 5 85 % 2) C 80 C 1) 110 C 5 85 % 2) Permitted rel. humidity during operation 1) Maximum at the Tc-point 2) Maximum 56 days/year at 85 % Lifespan ECG lifetime / h 1) / h 1) / h 1) / h 2) 1) Tc = 75 C, 0.2% / 1,000 h failure rate 2) Tc = 80 C, 0.2% / 1,000 h failure rate Additional product data Encapsulated No No No No OPTOTRONIC Intelligent Page 6 of 10

7 Capabilities Dimmable Dimming interface Dimming range Dimming method Yes DALI / Touch DIM / Touch DIM Sensor Yes DALI / Touch DIM / Touch DIM Sensor Yes DALI / Touch DIM / Touch DIM Sensor Yes DALI / Touch DIM / Touch DIM Sensor % 1) Amplitude Modulation % 1) Amplitude Modulation % 1) Amplitude Modulation % 1) Amplitude Modulation Constant lumen function Overheating protection Overload protection Programmable Automatic reversible Automatic reversible Programmable Automatic reversible Automatic reversible Programmable Automatic reversible Automatic reversible Programmable Automatic reversible Automatic reversible Short-circuit protection No-load proof Max. cable length to lamp/led module Suitable for fixtures with prot. class Automatic reversible Yes 2.0 m I / II Yes Automatic reversible Yes 2.0 m I / II Yes Automatic reversible Yes 2.0 m I / II Yes Automatic reversible Yes 2.0 m I / II Yes Suitable for emergency lighting Type of connection, output side Push terminal Push terminal Push terminal Push terminal 1) For maximum nominal output current Certificates & standards Approval marks approval ENEC 10 / VDE / EMC / EL / CE ENEC 10 / VDE / EMC / EL / CE / DALI-2 ENEC 10 / VDE / EMC / EL / CE / DALI-2 ENEC 10 / VDE / EMC / EL / CE / DALI-2 Standards Protection class Acc. to EN /Acc. to EN /Acc. to EN 55015/Acc. to EN 61547/Acc. to EN /Acc. to EN II OPTOTRONIC Intelligent Page 7 of 10

8 Standards Protection class Acc. to EN /Acc. to EN /Acc. to EN 55015/Acc. to EN 61547/Acc. to EN /Acc. to EN 62384/Acc. to EN 62386/Acc. to IEC :Ed2/Acc. to IEC :Ed2/Acc. to IEC :Ed1 Acc. to EN /Acc. to EN /Acc. to EN 55015/Acc. to EN 61547/Acc. to EN /Acc. to EN 62384/Acc. to EN 62386/Acc. to IEC :Ed2/Acc. to IEC :Ed2/Acc. to IEC :Ed1 Acc. to EN /Acc. to EN /Acc. to EN 55015/Acc. to EN 61547/Acc. to EN /Acc. to EN 62384/Acc. to EN 62386/Acc. to IEC :Ed2/Acc. to IEC :Ed2/Acc. to IEC :Ed1 II II I Type of protection IP20 IP20 IP20 IP20 Logistical data Temperature range at storage C C C C Application advice For more detailed application information and graphics please see product datasheet. Sales and Technical Support Sales and Technical Support Download Data File Product Datasheet OTi DALI A0 LT2 Certificates _VDE Certificate OPTOTRONIC Intelligent Page 8 of 10

9 Certificates _ENEC Certification_OT FIT CS Certificates _CB-Certificate-OTi DALI 15 Certificates _VDE_CB-Certificate-OTi DALI 15 Declarations of conformity _Declaration of Conformity_OTi DALI LT2 9C1 CAD data _OTi DALI 15_CAD file_igs CAD data _OTi DALI 15_CAD file CAD data _OTi DALI 15_CAD file_step CAD data _CAD Data OT-CableClamp-F-Style CAD data _CAD Data OT-CableClamp-F-Style CAD data PDF _CAD Data OT-CableClamp-F-Style Product Datasheet _TDS OTi DALI 25 Certificates _VDE license_oti DALI CAD data 3-dim _CAD OTi DALI 351A0 LT2 OTi DALI LT2 CAD data 3-dim _IGS - CAD OTi DALI 351A0 LT2 OTi DALI LT2 CAD data PDF _CAD OTi DALI 351A0 LT2 OTi DALI LT2 Product Datasheet _TDS OTi DALI 35 Product Datasheet Datasheet OTI DALI 50 CAD data 3-dim _STEP-CAD - OTI DALI A4 LT2 FAN CAD data PDF _CAD - OTI DALI A4 LT2 FAN CAD data PDF _IGS - CAD - OTI DALI A4 LT2 FAN Logistical Data OPTOTRONIC Intelligent Page 9 of 10

10 Product code Packaging unit (Pieces/Unit) Dimensions (length x width x height) Volume Gross weight OTi DALI 15/ /1A0 LT OTi DALI 25/ /700 LT OTi DALI 35/ /1A0 LT OTi DALI 50/ /1A4 LT2 FAN Shipping carton box 20 Shipping carton box 20 Shipping carton box 20 Shipping carton box mm x 207 mm x 90 mm 5.29 dm³ g 357 mm x 222 mm x 96 mm 7.61 dm³ g 357 mm x 222 mm x 96 mm 7.61 dm³ g 389 mm x 234 mm x 72 mm 6.55 dm³ g The mentioned product code describes the smallest quantity unit which can be ordered. One shipping unit can contain one or more single products. When placing an order, for the quantity please enter single or multiples of a shipping unit. Accessories Optional Accessory name Accessory code OPTOTRONIC Cable Clamp, F-STYLE OPTOTRONIC Cable Clamp, B-STYLE OPTOTRONIC Cable Clamp, B-STYLE TL OPTOTRONIC Cable Clamp, B-STYLE OPTOTRONIC Cable Clamp, B-STYLE TL OTi DALI 50/ /1A4 LT2 FAN OTi DALI 50/ /1A4 LT2 FAN OPTOTRONIC Cable Clamp, A-STYLE OPTOTRONIC Cable Clamp, A-STYLE TL Disclaimer Subject to change without notice. Errors and omission excepted. Always make sure to use the most recent release. OPTOTRONIC Intelligent Page 10 of 10