I/A Series Hardware Control Processor 60 Simplex

Transcription

1 Product Speciications I/ Series Hardware ontrol Processor 60 Simplex The ontrol Processor 60 Simplex (P60S) is a station that perorms regulatory, logic, timing, and sequential control together with connected ieldbus odules (s). It also perorms data acquisition (via the ieldbus odules) and alarm detection and notiication. The ontrol Processor 60S is a single-width processor module that does not provide ault-tolerant capability. It supports two basic types o s, those included in the IN rail mounted subsystem (201, 202, and so orth), and Y-odule orm actor s (01, 02, and so orth). It also supports communication with the Hydrostatic Interace Unit (HIU), ass lowmeter, and Panel isplay Stations, SPTRU igration, and ompetitor igration S ieldbus odules. or details, see evices Supported on page 2. The ontrol Processor 60 communicates with all associated devices via a bps thernet trunk ieldbus. The interace between the devices (s) and the bps thernet trunk ieldbus is via ieldbus ommunications odules ( or modules) and/or IN ieldbus onverter odules ( or ) or ieldbus Isolators (I modules). iagnostics The ontrol Processor 60S uses three types o diagnostic tests to detect and/or isolate aults: Power-up sel-checks Run-time and watchdog timer checks O-line diagnostics.

2 Page 2 Power-up sel-checks are sel-initiated when power is applied to the control processor. These checks perorm sequential tests on the various control processor unctional elements. Red and green indicators at the ront o the control processor module relect the successul (or unsuccessul) completion o the various phases o the control processor startup sequence. The run-time and watchdog timer checks provide continuous monitoring o control processor unctions during normal system operations. The operator is inormed o a malunction by means o printed or displayed system messages. O-line diagnostics are temporarily loaded into the system or the purpose o perorming comprehensive tests and checks on various system stations and devices. Using the o-line diagnostics, a suspected ault in the control processor can be isolated and/or conirmed. evices Supported The ollowing devices are supported by the ontrol Processor 60. ll IN rail mounted subsystem s (201, 202, and so orth) ll Y-odule orm actor s (01, 02, and so orth) oxboro Hydrostatic Interace Unit (HIU) oxboro ass lowmeter oxboro Panel isplay Stations luster I/O using P igration Integrator S ieldbus odules or Honeywell T 2000 Systems (H2xx series o s) S ieldbus odules or Honeywell T 3000 Systems (H3xx series o s) S ieldbus odules or the ailey NT90 and INI90 Systems S ieldbus odules or the isher PROVOX ontroller Series, Series and Series 20 Systems S ieldbus odules or Westinghouse Process ontrol WP Systems SPTRU igration Integrators (P11, P12, P13 and P14) SP 200 ontrol Integrator s SP 200 IRO ontrol Integrator s SP 200 ontrol Integrator s The oxboro Gas hromatograph is not supported. ieldbus odules ieldbus odules (s) provide the necessary conversion o digital I/O, analog I/O, and Intelligent Transmitter signals, allowing the corresponding signal values to be communicated to the control processor. wide range o s is available to perorm the various types o signal conversion necessary to interace the control processor with ield sensors and actuators. or urther inormation on the IN Rail ounted s, reer to Product Speciication Sheet PSS 21H-2W1 3. or urther inormation on the Y-odule orm actor s, reer to Product Speciication Sheet PSS 21H ieldbus lexibility The ontrol Processor 60S is used in two basic network conigurations, which provide broad lexibility in I/O subsystem implementation: irect Network oniguration (igure 1) In this coniguration, a direct connection is made between the control processor and the (s) and/or or I modules, with the possible option o a iber optic extension. ctive Star Network oniguration (igure 2) In this coniguration, a multiport iber optic converter (hub) urther extends the overall ieldbus distance, while adding application versatility and security. ither coniguration supports up to 120 ieldbus odules. (or coniguration purposes, the HIUs, ass lowmeters and Panel isplay Stations count as s.) or maximum cabling distances, reer to the unctional Speciications at the end o this PSS.

3 Page 3 ONTROL PROSSOR 60 S2 TO IR ONV. IR TO S2 ONV. IN RIL OUNT s (201, 202, T.), UP TO 30 PR OR PIR (S NOT 1) S2 ( bps) THRNT TRUNK ILUS (RUNNT) OPTIONL IR OPTI XTNSION O TH THRNT TRUNK ILUS IR OPTI S2 ( bps) THRNT LING TRUNK ILUS (RUNNT) 2 bps HL OUL ILUS (SHIL TWIST- PIR N/OR IR OPTI LING) SPLT-OUNT QUIP- NT (S PSS 21H-2X2 4 OR SPLT USG) I I S NOT 3 S NOT Kbps I/ SRIS HL ILUS Y-OUL OR TOR s (01, 02, T.), UP TO 24 PR I OR I PIR (S NOT 1) TO OTHR INVNSYS S2 QUIPNT (S NOT 5) VIS LIST UNR VIS SUPPORT ON PG 2, XPT OR SRIS 200 IN RIL OUNT S, Y-OUL OR TOR S, N WSTINGHOUS WP SYSTS NOTS: 1. OR ITIONL SIZING ONSTRINT INORTION, RR TO TH UNTIONL SPIITIONS T TH N O THIS OUNT. 2. US TH W TO ONNT WSTINGHOUS PROSS ONTROL WP SYSTS TO TH 2 bps ILUS. 3. TH I N US IN PL O TH. 4. TH ILUS ISOLTORS (Is) R NOT RQUIR WHN TH s R LOT IN TH S NLOSUR S TH s. 5., W,, I, HUS PO922KS N P0916J ONLY. NO OTHR QUIPNT IS PTL. igure 1. Typical irect Network oniguration

4 Page 4 ONTROL PROSSOR 60 OPTIONL IR OPTI XTNSIONS O TH THRNT TRUNK ILUS S2 TO IR ONV. IR TO S2 ONV. TO OTHR INVNSYS S2 QUIPNT (S NOT 5) S2 ( PS) THRNT TRUNK ILUS (RUNNT) IR OPTI LING IR OPTI L PIRS [H SH LIN IS ON PIR (TX + RX)] ULTIPORT IR OPTI ONVRTR (HU) (UP TO 6) S2 THRNT 2 bps HL OUL ILUS (SHIL TWIST- PIR N/OR IR OPTI LING) I I S NOT 3 S NOT Kbps I/ SRIS HL ILUS SPLT-OUNT QUIP- NT (S PSS 21H-2X2 4 OR SPLT USG) IN RIL OUNT s (201, 202, T.), UP TO 30 PR OR PIR (S NOT 1) Y-OUL OR TOR s (01, 02, T.), UP TO 24 PR I OR I PIR (S NOT 1) VIS LIST UNR VIS SUPPORT ON PG 2, XPT OR SRIS 200 IN RIL OUNT S, Y-OUL OR TOR S, N WSTINGHOUS WP SYSTS NOTS: 1. OR ITIONL SIZING ONSTRINT INORTION, RR TO TH UNTIONL SPIITIONS T TH N O THIS OUNT. 2. US TH W OR W TO ONNT WSTINGHOUS PROSS ONTROL WP SYSTS TO TH 2 bps ILUS. 3. TH I WITH IR TO S 2 ONVRTR N US IN PL O TH. 4. TH ILUS ISOLTORS (Is) R NOT RQUIR WHN TH s R LOT IN TH S NLOSUR S TH s. 5., W,, I, HUS PO922KS N P0916J ONLY. NO OTHR QUIPNT IS PTL. igure 2. Typical ctive Star Network oniguration

5 Page 5 UNTIONL SPIITIONS Processor Type ONTROL PROSSOR icroprocessor-based 486 X5 (running at 133 Hz) with stored programs, using high-speed communication capability. NOUS PROSSOR LN oprocessor ILUS PROSSOR 386 thernet Processor emory SIZ 8 storage RROR TTION providing single-bit error detection and correction. Process I/O ommunications (with s) THRNT TRUNK ILUS Type ase2 Transmission Rate bps OUL ILUS, VI Type HL, I RS-485 Transmission Rate 2 bps OUL ILUS, VI I OR Type HL, I RS-485 Transmission Rate Kbps able Lengths odule ieldbus IN RIL OUNT S Reer to PSS 21H-2W1 3 Y-OUL OR TOR S m (30 t) able Lengths ombined ONTROL PROSSOR 60 TO URTHST (USING OIN OXIL N IR OPTI LING) 20 km (12.4 mi) Process I/O apacity ILUS OULS(c) 120 maximum per ontrol Processor 60 depending on selected scan periods. (d) 30 s maximum per or module or redundant module pair 36 s maximum per W or W module or redundant module pair 24 s maximum per I or I module, or redundant module pair //W/I OULS 30 (maximum total),,,, W, or I modules, all o one kind or in any combination, per thernet trunk ieldbus aximum locks onigured The maximum number o blocks that can be conigured or use with the P60 (or redundant P60 pair) is (The number o blocks used depends on scan periods and block type selection.) The blocks in question include all types (control blocks, s, compounds, data blocks, and so orth). able Lengths thernet Trunk ieldbus THRNT TRUNK ILUS(a), S2 OXIL LING ONLY 185 m (607 t) maximum(b) IR OPTI XTNSION (TWN N TO IR-ST ONVRTRS 2 km (1.24 mi) maximum, each extension(b) XIU THRNT TRUNK SGNTS Three ase2, joined by two iber optic extensions IR ISTN RO HU TO,, OR IR ONVRTR (OR I) 2 km (1.24 mi) maximum(b) Power Requirements INPUT VOLTG (RUNNT VOLTG) 39 V dc typical ONSUPTION 15 W, maximum Indicators Red and green light-emitting diodes (Ls) indicate operational status. Internal iagnostics Sel-checking perormed at power-up. Run-time checks and the watchdog timer unction perormed during operation. (a) The thernet trunk ieldbus connects between the ontrol Processor 60 and the s and/or or I modules in the irect Network oniguration (igure 1), and between the ontrol Processor 60 and the hub(s) in the ctive Star coniguration (igure 2). (b) In any speciic application, individual maximum cable lengths may be aected by (limited by) the overall maximum allowable cable length (20 km) between the ontrol Processor 60 and the arthest. (c) or coniguration purposes, HIUs, ass lowmeters, Panel isplay Stations, etc. are counted as s. (d) Reer to ontrol Processor 60 (P60) Sizing Guidelines and xcel Workbook (0400K).

6 Page 6 Operating TPRTUR 0 to 60 (32 to 140 ) RLTIV HUIITY 5 to 95% (noncondensing) LTITU -300 to +3,000 m (-1,000 to +,000 t) NVIRONNTL SPIITIONS(a) Storage TPRTUR -40 to +70 (-40 to +158 ) RLTIV HUILY 5 to 95% (noncondensing) LTITU -300 to +12,000 m (-1,000 to +40,000 t) (a) The environmental ranges can be extended by the type o enclosure containing the module. [Reer to the applicable Product Speciication Sheet (PSS) which describes the speciic enclosure that is to be used.] oniguration Single-width processor module ass (aximum) 1.7 kg (3.75 lb) PHYSIL SPIITIONS ounting ay be placed in any o the ollowing I/ Series mounting structures: 1x8 ounting Structure Industrial nclosures, Structural oam or etal ield nclosures, Structural oam or etal

7 Page 7

8 Page 8 33 ommercial Street oxboro, United States o merica Inside U.S.: Outside U.S.: or contact your local oxboro representative. acsimile: Invensys, oxboro, and I/ Series are trademarks o Invensys plc, its subsidiaries, and ailiates. ll other brand names may be trademarks o their respective owners. opyright Invensys Systems, Inc. ll rights reserved 021 Printed in U.S