Hotel Lighting. Lua4RC Application VT8300. Local HVAC System (No reheat) Local lighting system SED-WDN-P-5045 SED-DOR-P-5045.

Size: px

Start display at page:

Download "Hotel Lighting. Lua4RC Application VT8300. Local HVAC System (No reheat) Local lighting system SED-WDN-P-5045 SED-DOR-P-5045."

Octavia Mosley
5 years ago
Views:

1 Hotel Lighting Lua4RC Application Door Switch SED-WDN-P-5045 SED-DOR-P-5045 VT8300 Local lighting system Local HVAC System (No reheat)

2 2 INTRODUCTION This script can be used to control a master lighting contact with the Auxiliary output of a VT8300 series Room Controller. The built-in logic of the Auxiliary output was designed for reheat applications. It includes a 10 seconds delay between the Effective occupancy change and the output action. Using the Lua4RC script will remove this delay and make lighting applications possible. HARDWARE REQUIREMENTS Qty Part Number Description VT8300 Series and newer Room Controller SOFTWARE REQUIREMENTS Files File name Version Comment Lua4RC_002_00.lua v.1.0 Wireless Lua script, used in PG1 Lua4RC_002_01.lua v.1.0 Wired Lua script, used in PG1

3 3 WIRING DIAGRAM VT8300 BO2 - Fan L BO3 - Fan M BO4 - Fan H RC (24 Vac) C (Common) RH BO8 - Aux Heat UO9 - NC Cool V UO10 - NC Heat V UO11 - NO Cool V UO12 - NO Heat V On / Off MASTER LIGHTING CONTACTOR 110v 24 VAC COMMON 24 VAC TRANSFORMER BACnet + BACnet - BACnet REF UI 16 UI 17 Common UI 19 UI 20 - RS Common UI22 - SS VT8300 Binary Outputs BO8 Aux out

4 4 USER VARIABLES This section presents a table of Lua for VT8000 user variables and defines their use in the script. User variables can have one of two roles in a script: 1. User input: value that has to be entered by the user. It is a constant used in the script 2. Script output: the value of a script output variable is set by the script User Variables Description Type ME.BV1 Door status User input ME.BO98 BO8 activation (enable/disable lighting circuit) Script output SEQUENCE OF OPERATION This script controls the state of Auxiliary output based on room occupancy for lighting applications. Closing the contact will enable local lighting controls. Opening the contact will close all lights connected to this circuit. Room states: Unoccupied -> Room is considered unoccupied when no motion is detected for Unocc.time duration in standby state. StandBy -> Room goes to standby state 10 seconds following the door closing. Occupied -> The room becomes Occupied as soon as motion is detected. NOTE: an occupied room will not change state unless door is opened then closed. Lighting states: Enabled -> Lighting is enabled as soon as the door opens and remains enabled as long as door stays opened. Lighting is enabled as long as the room is in Occupied or Standby state. Disabled -> Lighting is disabled in Unoccupied state

configuration. IMPORTANT: If Door installed value shows No, a Zigbee Door Contact must be binded.

5 5 SE8300 CONFIGURATION 1. Navigate to ZigBee menu screen 2 (2/2) and ensure Door installed value shows Yes to proceed with script configuration. IMPORTANT: If Door installed value shows No, a Zigbee Door Contact must be binded. Refer to Zigbee Pairing Procedure and Lua Programming Guide to bind a Door Contact. 2. In Configuration menu screen 3 (3 /7), set duration (hrs) for Unocc. time to a value greater than 0 hrs. 3. In Configuration menu screen 4 (4 /7), set BO8 AuxOut to Aux No (normally open). 4. In Configuration menu screen 5 (5 /7), set Seq. operation to any of the following values: Cool only, Heat only or Cool/Heat. Note: Do Not use any Reheat values

6 6 FEEDBACK AND REFERENCES We hope that this application document, script example and associated information (the information ) is valuable to you. Your use of this information, however, is at your sole risk. All information is provided as -is, without any warranty, whether express or implied, of its accuracy, completeness, fitness for a particular purpose, title or non-infringement, and none of the third-party products or information potentially mentioned in the work are authored, recommended, supported or guaranteed by Viconics Technologies inc.. Viconics Technologies inc. shall not be liable for any damages you may sustain by using/installing/modifying this information, whether direct, indirect, special, incidental or consequential, even if it has been advised of the possibility of such damages. Further, Viconics Technologies can not guarantee updates, sustaining or support for the information. If any kind of support is given in relation to this application note, it will be done without prejudice and with no implied warranty. DISCLAIMER We hope that this application document, script example and associated information (the information ) is valuable to you. Viconics does not test the program using any actual equipment, and therefore, your use of this information is at your sole risk. All information is provided as -is, without any warranty by Viconics, whether express or implied, of its accuracy, completeness, fitness for a particular purpose, title or non-infringement, and none of the third-party products or information potentially mentioned in the work are authored, recommended, supported or guaranteed by Viconics Technologies inc.. All Lua Scripts are furnished free of charge. Viconics Technologies inc. shall not be liable for any damages you may sustain by using/ installing/modifying this information, whether direct, indirect, special, incidental or consequential, even if it has been advised of the possibility of such damages. Further, Viconics Technologies can not guarantee updates, sustaining or support for the information. If any kind of support is given in relation to this application note, it will be done without prejudice and with no implied warranty.

Hotel Lighting. Lua4RC Application VT8300. Local HVAC System (No reheat) Local lighting system SED-WDN-P-5045 SED-DOR-P-5045.

Hotel Lighting. Lua4RC Application VT8300. Local HVAC System (No reheat) Local lighting system SED-WDN-P-5045 SED-DOR-P-5045. Hotel Lighting Lua4RC Application Door Switch SED-WDN-P-5045 SED-DOR-P-5045 VT8300 Local lighting system Local HVAC System (No reheat) 2 Lua4RC Application Hotel Lighting INTRODUCTION This script can be