Nanoleaf Light Panels

Transcription

1 Nanoleaf Light Panels Large Installation Setup Guide

2 Product Introduction This is the star of the show, the flat smooth side is the side that will light up. Light Panels Used to figure out the design on the wall before mounting the actual panels. Stencil Paper Place one in between the panels to secure the panels to the wall using nails. The extra sides can be broken off if necessary. This is the power supply used to supply power to the panels. PSU Mounting Kit This links to the PSU and connects power to the panels. Attach to any panel to power the panels. Each controller can support maximum 30 panels. Controller These linkers are used to connect the panels together. Only one linker is needed per panel in a chain. Linkers By default, the panels are attached using 3M command tape. 3M Tape Use to link a group of panels around corners. Flexible linkers

3 App Installation Guide Nanoleaf Smarter Series App Make sure your smart device is connected to NON-5G Wifi, and open the App to begin connecting the controllers. We suggest to power your controllers on one at a time to avoid confusion during app setup. The pairing code is behind the controller, so you ll need to scan the pairing code if you are using an Apple device. Visit to watch setup videos.

4 Hardware Installation Guide Be sure to test out the panels on the floor or any flat surface BEFORE taping onto the wall. Plan out the design you d like to do, and make sure that you only connect up to 30 panels using linkers. Each controller can only support 30 panels, so please ensure that you DO NOT connect more than 30 panels together using linkers even if the design is larger than 30 panels. Stencil Paper Wall Panels IMPORTANT: Before mounting the panels, clean the wall / surface so it s free of dust, oil, or moisture. Otherwise the 3M command Strips will not stick properly and the panels will fall off. Use 2-3 pieces of 3M command strips per panel to fully secure the panels to the wall.

5 During installation, it is important to keep the panels powered on using a controller at all times to make sure each panel is attached correctly. This will help to prevent any complications resulting from attachment mistakes during the install. 2. Linker Controller Rhythm

6 Each group of up to 30 panels will require a separate controller. To create a large design, simply tape panels next to each other without linking the groups of panels to each other. 30 panels 30 panels Don t connect together with linkers. Note: 30 panels per Rhythm module. Each additional 30 panels must use a new module just like the controllers. For CEILING mounting, you will need to use mounting kits to secure the panels to the ceiling using nails. 3M command strips will not stick to the ceiling, and will inevitably fall off over time. Mounting Kits Screw Mount x4 Flex Linkers Philip Pan Screws Cut to fit. Screw to wall. Screw Screw Mount Cap Drywall Anchor Plaster Anchor

7 LAYOUT ASSISTANT location in the APP If you need help brainstorming a design, please visit our Layout Assistant in the App s More page. For viewing your layout assistant design on your actual wall, please scan the QR code below from within the Layout Assistant.

8 Controlling Multiple Controllers At Once 1. Use the Group function in the app to enable controlling multiple controllers with one click. 2. Create a scene and add the Light Panels Controllers into this scene. 3. Choose which Scene you d like to trigger when this is activated. 4. You re all good to go! Note: Do not connect more than 10 controllers to a group, this will cause lag and unstable operations of the light panels. If you have more than 10 controllers, please use an additional smart device to control those extra controllers.

9 Trouble-shooting: 1. North America: Everywhere else: Please contact your account manager for immediate support during your set-up. 3. Visit to view support articles that may help to answer your questions.